629516
7
Zoom out
Zoom in
Previous page
1/80
Next page
Safety Instructions and Important Information
7
Power supply cable
Make sure that the power supply cable is not damaged. Units with a damaged
power supply cable
must be
disconnected from the power supply and repaired by a qualifi ed engineer before setup.
Risk
of death due to electric shock.
Fuse in cable and receiver
Removing or bridging the fuse in the cable or the receiver is prohibited.
A defective fuse should only be replaced by a fuse with the same rated value
!
Risk of fi re due to short circuit.
Cleaning
Disconnect the unit from the power supply before cleaning it. Only use a dry cloth for cleaning, and only clean the
outer surface. Never open the unit.
Touching the parts inside the unit carries a risk of death due to electric shock.
Playing children
Make sure that children do not push any objects into the ventilation slots.
Risk of death due to electric shock.
Earthing
The antenna system must be earthed as specifi ed or equipotentially bonded. The requirements of EN 60728/11 and
any national regulations must be met.
Danger due to surge voltages, lightning strikes.
Mains voltage
Only operate the unit at the specifi ed mains voltage (indicated on the rear of the
unit or on the external power pack)!
The unit may only be connected to the mains and turned on
once it has been connected to the antenna and to the TV
set or the cable network and PC.
If the mains voltage is too high, there is a risk of fi re.
Vehicle height
Risk of accidents due to exceeding normal vehicle height by failure to lower antenna.
The driver is responsible for the condition of the superstructure and external fi ttings
.
Failure to lower the antenna can result in severe damage to the antenna and to the vehicle.
Repairs
Ensure that any repairs
to your unit are only
carried out by qualifi ed personnel. Opening the unit and attempting to
repair it
yourself results in forfeiture of all warranty claims
!
Improper work on the unit can endanger the electrical safety of the unit.
The manufacturer shall accept no liability for accidents caused by the user opening the unit!
Connections
Incorrect wiring of the connections can lead to operating faults or defects on the
unit
!
Long periods of absence / storms
Always turn off the unit at the power switch if you will be absent for a long time or there is a storm. This also applies
to the other equipment connected to the unit. Wiring harness isolation is also recommended. Note any timer
programmes (receiver) and turn the unit on again promptly before the recording time.
Installation location
Every piece of electronic equipment generates
hea
t. However, the heating of this unit lies within the permissible
range. Sensitive furniture surfaces and veneers may become discoloured by the
effects of
heat over time. The feet
effects of heat over time. The feet effects of
of the unit can also cause colour changes to treated furniture surfaces. If necessary, place the unit on a suitable
stable and fl at base.
Ventilation
The heat occuring in this
unit is adequately dissipated. Never install the
unit
in a cupboard or on shelves with
inadequate ventilation.
Never cover the cooling slots on the
unit!
No not place any
objects on top of the unit and maintain at least 10 cm of free space above the unit so that the
resulting
heat can be dissipated properly
.
Moisture, sunlight, he
at
The unit should be protected from moisture, dripping water and spray. Do not place the unit
close to the heating or
expose it
to
direct sunlight, and do not operate it in damp locations.
DANGER!
WARNING!
ATT
EN
TION!
This page contains important information on the operation, installation location and connection of the unit.
Read these instructions carefully before setting up the unit.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein UFD 170 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein UFD 170 in the language / languages: English as an attachment in your email.

The manual is 5,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info