473814
14
Zoom out
Zoom in
Previous page
1/68
Next page
14
Create the holes necessary to secure the mounting plate (Fig. C).
• In addition to the bolted connection, the mounting plate and roof gland must be bonded to the roof
with adhesive and sealed. This is done using the Sika ex
®
291 adhesive sealant supplied, which is
ideally suited for this purpose thanks to its broad range of adhesion.
Before starting to use Sika ex
®
291 adhesive sealant, be sure to read the Sika ex
®
Products
safety data sheet and technical data sheet in this installation manual!
The prerequisite for good adhesive characteristics is a clean, dry and grease-free substrate. You should
therefore clean the roof surface with a suitable cleaning agent within a circumference of 17 cm around
the drilled hole and allow the surface to dry thoroughly.
If the surface is painted, ensure that the paint nish is suf ciently well bonded to the substrate.
If the coat of paint is already loose or peeling, it must be removed down to a stable layer in the area
to which the adhesive will bond. If you have any doubts concerning the adhesive characteristics, consult
a paint and lacquer specialist, or the manufacturer of your vehicle.
Under certain circumstances, it may be necessary for you to improve the adhesive properties of the roof
surface by pre-treatment with a cleaning agent available from specialist dealers (e.g. Sika
®
Cleaner) or
a primer (e.g. Sika
®
Primer).
The procedure for gluing the mounting plate is as follows:
INSTALLATION AND CONNECTION
Figure: D
Recess
for cable
Adhesive area between
the two grooves
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein MobiSet 2 digitaal CAP 610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein MobiSet 2 digitaal CAP 610 in the language / languages: English as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein MobiSet 2 digitaal CAP 610

Kathrein MobiSet 2 digitaal CAP 610 User Manual - German - 68 pages

Kathrein MobiSet 2 digitaal CAP 610 User Manual - Dutch - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info