424707
19
Zoom out
Zoom in
Previous page
1/48
Next page
936.2391/D/0806/7.12e
3. Now loosen one wing nut on the mast bracket. Turn the
antenna around the mast axle (Azimuth) toward the position
where the desired satellite is (basic direction is South) until
you receive the selected programme.
4. Tighten the wing nut slightly. The antenna is now roughly
aligned.
Instructions for alignment with analogue receivers
5. Loosen the elevation screw again. Move the antenna slight-
ly up and down until you see the rst ”spikes“ in either case
on the screen of your television set.
The best picture quality is found in the middle of these two
positions. The elevation of the antenna is then optimised.
Slightly tighten one elevation screw again.
Instructions for alignment with digital receivers
6. The signal quality is displayed in the menu „Installation &
Settings”, „TV Reception & Channel Search“ and „Signa
Reception“ (UFS 601si).
Note:
The Azimuth position of the antenna will be slightly altered when the wing nuts of the mast clamp are tightened.
This twisting effect can be useful for optimising, but it must be taken into account for the subsequent tightening.
7. Tighten the wing nuts crossways. The wing nuts are screwed tight enough if they are rst tightened slightly and
then fully tightened with the aid of an open-ended spanner (13 mm jaw size).
8. Next, slightly tighten the left and the right elevation screws of the mast clamp, taking for this purpose the short
shank of the Allen key into your hand.
9. Then take the longer shank of the key into your hand and tighten the two screws effecting a 1/4 to 1/2 turn.
10. After the antenna has been positioned and is rmly xed, check if all screws have been suf ciently tightened.
11. Secure the cable on the support arm with the aid of cable binders in order to avoid that the cable gets damaged.
10. Grounding the antenna/Lightning protection
According to the VDE EN 50083-1 safety regulations, it is imperative to ground the antenna.
Exempted from these regulations are antennas
- which are installed 2 m below the edge of the roof
- and are mounted less than 1,5 m away from a building
Danger exists not only during a thunderstorm but also because of static charge of connected appliances which can
trigger short-circuits.
Therefore, it is necessary that the antenna support and the outer conductor of the antenna cable be grounded via
an appropriate vertical earthing wire which is connected to the lighting protection system of the house (if no such
system exists, connection to the earthing conductor of the building is necessary).
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein bas 62 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein bas 62 in the language / languages: German as an attachment in your email.

The manual is 4,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info