424707
18
Zoom out
Zoom in
Previous page
1/48
Next page
936.2391/D/0806/6.12e
d) Connecting the cable (Fig. F)
1. Prepare the cable (outer diameter 6.8
mm) as shown in the illustration.
Screw on the supplied F-connector. In
case you use a cable with a different
outer diameter, procure a suitable F-
connector.
2. Loosen the two milled screws of the
LNB cover and remove the cover.
3. Lay the cable according to Fig. F and
connect the cable to the LNB by means
of the F-connector´s cap nut.
4. Now press the cable (outer diameter 6.8
mm) into the cable support. If you use a
thinner cable, put fi rst the supplied slee-
ve on the cable in order to compensate
the diameter.
5. Put the LNB cover back on its place.
8. Connecting and tuning a satellite receiver
1. Connect the fl at antenna with the satellite receiver by plugging the cable into the ”IF-Input“ on the satellite recei-
ver.
2. Connect your TV set with the satellite receiver by means of an audio/video cable. Select the ”AV“ programme
position on your TV set.
3. If you use the modulator output of the satellite receiver, select the same channel on your TV set to which the
output of the satellite receiver has been tuned. Save this channel on a free programme position on your TV set.
4. Alignment to the desired satellite requires that you select a corresponding programme position on the satellite
receiver (see programme table for the satellite receiver).
Detailed information regarding the operation of the satellite
receiver is found in the receiver´s operating instructions.
9. Positioning and affi xing the antenna
1. Gather the relevant elevation angle for the installation site
from the enclosed Azimuth/Elevation table.
2. Loosen the tightened elevation screws again and move the
antenna into the required elevation position. The angle can
be read off from the elevation scale on the mast clamp.
Tighten the elevation screw again slightly. For the following
steps you need a satellite signal meter or someone who
is watching the positioning procedure on the TV set. If you
use a Kathrein MSK ... signal meter, connect the signal
meter to the LNB (instead of the antenna cable).
Position the antenna in compliance with the maximum si-
gnal level the meter indicates. If the positioning is done with
the aid of a TV set, align according to best picture quality.
Braiding overturned
Connecting the cable
Fig. F
Sleeve for use
with a thinner
cable
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein bas 62 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein bas 62 in the language / languages: German as an attachment in your email.

The manual is 4,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info