Manual Karcher KM 100-100 R Bp (page 21 of 396) (All languages)

804786

Zoom out

Zoom in

1/396

- 5

CAUTION

Regularly check the fluid level in acid-filled

batteries.

– The acid in a fully charged battery has a

specific weight of 1.28 kg/l at a temper-

ature of 20 °C.

– The acid in a partially discharged bat-

tery has a specific weight between 1.00

and 1.28 kg/l.

– The specific weight of the acid must be

uniform in all cells.

Unscrew all cell caps.

Take a sample from each cell using the

acid tester.

Put the acid sample back into the same

cell.

Where fluid level is too low, top up cells

to the mark provided with distilled wa-

ter.

Charge battery.

Screw in cell caps.

DANGER

Risk of injury and damage! Do not use a

forklift to unload the appliance.

Note: Press the emergency-stop button to

immediately deactivate all functions and

turn the key switch to the "0" position.

To unload the machine, proceed as follows:

Cut plastic packing belt and remove foil.

Remove the elastic tape fasteners at

the stop points.

Four indicated floor boards of the pallet

are fastened with screws. Unscrew

these boards.

Place the boards on the edge of the pal-

let. Place the boards in such a way that

they lie in front of the four wheels of the

machine. Fasten the boards with

screws.

Slide the four support beams included

in the packaging under the ramp.

Remove the wooden blocks used for ar-

resting the wheels and slide them under

the ramp.

Loosen immobilizing brake (see "move

sweep machine").

Slide the machine over the prepared

ramp from the pallet.

Connect battery (see section on Care

and maintenance)

Release emergency-stop button by

turning.

Set programme switch to step 1 (driv-

ing).

Set main switch to "1".

Slowly drive the appliance off the ramp.

Set main switch back to "0".

Danger

Risk of injury! Before releasing the immobi-

lizing brake, the machine must be secured

to prevent it rolling away. After releasing

the immobilizing brake, the machine roles

without brakes.

Remove the brake level from the wheel

and put it in its position.

The immobilizing brake is thus deactivated;

the machine can now be moved.

Park the sweeper on an even surface.

Remove the key.

Check charging status of battery.

Check side brush.

Check roller brush.

Shake off dust filter.

Empty waste container.

Check tyre pressure.

Note: For description, see section on Care

and maintenance.

Open the hood, insert retaining rod.

Release the wing nuts from the seat

rails.

Slide the seat into the desired position.

Tighten the wing nuts.

Note: If this adjustment is not enough, it

can be adjusted more.

Remove 4 screws on the plate of the

seat contact switch.

Remove the plate.

Swivel the seat to the front.

Loosen 4 screws on the seat support.

Slide the seat and tighten the screws.

Install the plate of the seat contact

switch.

– Indicator lamp glows green

Battery is charged.

– Indicator lamp glows yellow

Battery is almost discharged.

Terminate the sweeping operation and

charge the battery.

– Indicator lamp blinks red

Discharging limit has been reached. Anoth-

er 3 minutes of driving operation remain;

then the appliance will switch off.

The appliance cannot be restarted, the

battery must be charged for at least 3

hours.

– Indicator lamp glows red

Battery is discharged. The control has

switched off the sweeping system.

Charge battery.

Check fluid level in the battery and ad-

just if required

Unloading

(1) Machine without built-in battery

(2) Machine with built-in battery

Move the sweep machine

Start up

General notes

Inspection and maintenance work

Operation

Adjusting driver's seat

Check charging status of battery

21EN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher KM 100-100 R Bp in the language / languages: All languages as an attachment in your email.

The manual is 153.98 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher KM 100-100 R Bp Manual

Product: