804647

Karcher IVM 40-24-2 M Lp Manual

16
Zoom out
Zoom in
Previous page
1/232
Next page
16 English
open the flap at the outlet (only possible
when the device is switched off).
3. Pull the waste hose down somewhat.
4. Close the waste hose using 2 cable ties
at a spacing of 10 cm.
5. Cut the waste hose between the cable
ties.
6. Dispose of the waste bag in accordance
with statutory regulations.
Note
With light suction material, the length of the
waste bag can be up to 2 m without the
waste bag tearing.
Reading the minimum volumetric
flow
A pressure gauge showing the vacuum in-
side the device is mounted on the front of
the device. The filter must be cleaned when
the maximum vacuum (see table) is
reached (see chapter Dedusting the filter).
This value depends on the device perfor-
mance and the suction hose used. If the
vacuum is not significantly reduced by de-
dusting, the filter must be replaced (see
chapter Replacing the filter).
ATTENTION
Exceeding the maximum vacuum
Suction loss
If the specified value is exceeded, the air
speed in the suction hose drops below
20 m/s. Clean or replace the filter.
Dedusting the filter
The filter must be cleaned if the pressure
gauge shows the maximum vacuum (see
chapter Reading the minimum volumetric
flow).
Illustration E
1. Close the inlet opening or the suction
hose during the suction process.
2. Pull the flap of the filter dedusting sys-
tem 3-4 times and hold it open for 1-
2 seconds each time.
Switching off the device
1. Switch off the device via the suction tur-
bine power switches.
2. Pull out the mains plug.
Each time after use
Closing the suction connection
몇WARNING
Risk of injury
Damage to the skin, lungs and eyes
through fine dust
The suction connection must be closed us-
ing the sealing plug after removing the suc-
tion hose.
1. Remove the suction hose.
Illustration F
2. Insert the sealing plug precisely into the
suction connection.
3. Push the sealing plug in all the way to
the end stop.
4. Turn the sealing plug to the right until the
suction connection is tightly closed.
Removing the disposal system
1. Secure the device with the parking
brakes.
Illustration G
2. Release the locks on the filter ring and
remove the disposal system forwards.
Cleaning the device
몇WARNING
Improper disposal of waste water
Environmental pollution
Observe the local waste water treatment
regulations.
1. Vacuum the inside and outside of the de-
vice and clean with a moist cloth.
A vacuum cleaner with the same or bet-
ter classification must be used for vacu-
uming the device.
2. If necessary, rinse the accessories (not
included in the scope of delivery) with
water and dry them.
Nominal width of
the suction hose
Maximum vacuum
DN40 12.70 kPa
(127.0 mbar)
DN50 8.75 kPa
(87.5 mbar)
DN70 ---
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher IVM 40-24-2 M Lp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher IVM 40-24-2 M Lp in the language / languages: All languages as an attachment in your email.

The manual is 4.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info