804749
22
Zoom out
Zoom in
Previous page
1/300
Next page
- 9
Faults without display on the console
Fault Remedy
Machine does not move Stand-by. Turn the appliance off and reinsert the Intelligent Key.
Turn the program selection switch to the desired programme.
Only for B 80 W Bp Dose Colruyt: Release the emergency buttons by turning.
Release parking brake.
Check battery; charge it if required.
Make sure that all battery terminals are connected.
Insufficient water quan-
tity
Check fresh water level, refill tank if necessary.
Increase the water volume on the regulating knob for water volume.
Unscrew the lock of the fresh water reservoir. Remove and clean the fresh water filter. Insert the filter and screw
in the lock.
Remove the water distribution strip from the cleaning head and clean water canal (only R cleaning head).
Check hoses for blockages; clean if required.
Do not add detergents Increase the water volume to activate the dosing pump.
Check the detergent level
Insufficient vacuum per-
formance
Clean the seals between waste water tank and cover and check for tightness, replace if required.
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean protective turbine strainer.
Clean the vacuum lips on the vacuum bar, replace if required
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Insufficient cleaning re-
sult
Check the brushes for wear, replace if required.
Vibrations during clean-
ing
Cleaning head has play, open the excenter lever and press the cleaning head all the way against the push han-
dle, close the excenter lever.
You might need to use softer brushes.
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter if required.
If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF".
Afterwards, set it back to the desired programme.
In case of faults that cannot be remedied using the table below please contact the customer service.
Accessories
BR appliance B 80 (brush roller accessories)
Description Part no.:
Working width
650 mm
Part no.:
Working
width 750
mm
Description
Packaging unit
Appliance requires
Brush roller, red (medium, standard) 6.906-935.0 6.906-936.0 Also for regular cleaning of heavily dirtied
floors.
12
Brush roller, white (soft) 6.906-981.0 6.906-985.0 For polishing and cleaning sensitive floors. 1 2
Brush roller, orange (high/ low) 6.906-982.0 6.906-986.0 For scrubbing structured floors (safety tiles,
etc.).
12
Brush roller, green (hard) 6.906-983.0 6.906-987.0 For thoroughly cleaning heavily dirtied floors
and for removing the coating (for e.g. of wax,
acrylate).
12
Brush roller, black (very hard) 6.906-984.0 6.906-988.0 1 2
Pad roller shaft 4.762-433.0 4.762-434.0 For intake of roller pads. 1 2
Roller pad, yellow (soft) 6.369-454.0 6.369-454.0 For polishing floors. 20 96; 106
Roller pad, red (medium) 6.369-456.0 6.369-456.0 For cleaning slightly dirtied floors. 20 96; 106
Roller pad, green (hard) 6.369-455.0 6.369-455.0 For cleaning normal to heavily dirtied floors. 20 96; 106
22 EN
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher B80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher B80 in the language / languages: All languages as an attachment in your email.

The manual is 40.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info