804757
22
Zoom out
Zoom in
Previous page
1/452
Next page
22 English
Installing he brushes
1. The installation of the brushes is described
in the chapter "Maintenance work".
Installing the suction bar
1. Pivot both clamping levers upwards.
1Suction hose
2Suction bar suspension
3Suction bar
4Clamping lever
2. Insert the suction bar in the suction bar
mount.
3. Pivot both clamping levers downwards.
Batteries
Recommended battery sets
* Minimum volume of the battery charging room
** Minimum airflow between battery charg-
ing room and environment
Installing and connecting batteries
CAUTION
Removing and installing the batteries
Unstable machine position
Ensure that the machine is positioned stably
when removing and installing the batteries.
ATTENTION
Incorrect connection polarity
Destruction of the control electronics
Take care to ensure the correct polarity
when connecting the batteries.
ATTENTION
Deep discharge
Risk of damage
Charge the batteries before starting the de-
vice.
1. Drain the waste water.
2. Unlock the waste water tank and pivot it up.
3. Place the battery in the device.
170 Ah, 4.039-352.7
1Spacer 310x85x70 mm
2Spacer 240x55x30 mm
180 Ah, 4.039-354.7
1Spacer 310x85x70 mm
285 Ah, 4.039-353.7
1Spacer 345x60x47
4. Insert the spacers at the locations
shown in the picture between the battery
and the device.
5. Connect the battery terminals using the
connection cables provided.
6. Clamp the connecting cables on the (+)
and (-) battery terminals that are still
free.
Note
For the 170 Ah 4.039-352.7 battery set, at-
tach the connection cable to the negative
pole with the insulated pole screw.
7. Connect the device-side battery connec-
tor to the battery-side battery connector.
8. Pivot the waste water tank forwards and
close it.
Removing the battery
CAUTION
Removing and installing the batteries
Unstable machine position
Ensure that the machine is positioned stably
when removing and installing the batteries.
1. Set the safety switch to "0".
2. Drain the waste water.
3. Unlock the waste water tank and pivot it up.
4. Pull out the battery plug.
5. Disconnect the cable from the minus ter-
minal at the battery.
6. Disconnect the remaining cables from
the battery.
7. Remove the battery.
8. Dispose of the used batteries in accord-
ance with statutory provisions.
Initial startup
Charging the battery
DANGER
Inappropriate use of the charger
Electric shock
Adhere to the mains voltage and fuse val-
ues specified on the device type plate.
Only use the charger in dry rooms with suf-
ficient ventilation.
Flammable gases are generated when
the battery is charged
Risk of explosion
Only charge the battery in a suitable room.
The room must have a minimum volume
depending on the battery type and an ade-
quate air exchange rate with a minimum air
flow (see "Recommended batteries").
ATTENTION
Accumulation of dangerous gases under
the tank during the charging process
Risk of explosion
Pivot the waste water tank upwards before
charging low-maintenance batteries.
The average charging time is approx. 10-
15 hours.
The device cannot be used during the
charging process.
Note
The device has deep discharge protection,
i.e. the brush motor and turbine are
switched off automatically when the permit-
ted minimum capacity level is reached.
1. Drive the device directly to the charger
and do not drive on slopes.
External charger
ATTENTION
Using an unsuitable charger
Risk of damage
Do not connect the charger to the device-
side battery connector.
Use only a charger suitable for the type of
battery installed.
Read the operating instructions of the
charger manufacturer and observe the
safety instructions in particular.
1. Unlock the waste water tank and pivot it up.
2. Pull out the device-side battery connector.
Descrip-
tion
Order no. Volume
(m3)*
Airflow
(m3/h)**
170 Ah -
Mainte-
nance-
free, AGM
4.039-
352.7
2.4 1.0
180 Ah -
Mainte-
nance-
free, gel
4.039-
354.7
3.8 1.6
285Ah -
Mainte-
nance-
free, AGM
4.039-
353.7
12.6 5.1
Battery Capacity Charger
4.039-352.7 170 Ah 6.654-436.0
4.039-354.7 180 Ah 6.654-434.0
4.039-353.7 285Ah 6.654-419.0
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher B 110 R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher B 110 R in the language / languages: All languages as an attachment in your email.

The manual is 30.79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info