491054
8
Zoom out
Zoom in
Previous page
1/24
Next page
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don’t change the page
numbering. Keep the languages integrity.
8
Assembly page 8/24
Fax +32 2 359 95 50
CONTROLLING
This equipment has a power switch, an Economiser switch and a fire adjustable switch.
POWER SWITCH
The appliance can operate in 5 different modes.
FIRE ADJUSTABLE SWITCH
You can enjoy the fire effect even if the heater has been switched off.
The fire adjustable switch enables you to set the fire and light intensity.
When in the minimum position, the fire effect and the light have a weak intensity.
To get a higher heat, turn the switch clockwise.
ECONOMISER SWITCH
When you chose middle heat or high heat (in low heat position energy saving does not operate),
this sensible heat output controller will automatically open or close the heating element in order
to keep selected heat.
First turn the Economiser switch clockwise to the highest heat (9).
When the room temperature reaches the requested level, turn the switch anticlockwise to lower
the heat and switch off the heating elements.
It keeps the necessary room temperature and saves energy.
MAINTENANCE
WARNING: Always disconnect the appliance before cleaning or maintenance.
Replacing the bulb
Below the fire source there are two lights. Move down the front glass plate (there are 2 screws on the
slide at the part of the glass), carefully put it aside. Lightly press the middle part of the glass; lift the
glass toward the front and up then move away. When taking the light bulb, firstly press the lampstand,
then rotate anticlockwise and take out.
Type of bulb
2x25W small light.
When reassemble be sure to put the transparent side of the glass inside.
REMOVING THE PROTECTION GRID
Unscrew the lower part of the protection grid, it will let down slightly. Then draw the higher part of
the grid to remove it. To put it back, do the opposite.
CLEANING THE REFLECTOR
Remove the heating elements first.
Clean the reflector with a cloth slightly damped with soapy hot water, then wipe with a soft and
dry cloth.
Do not use detergents or cleaning products.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik KA CH 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA CH 1 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info