57099
21
Zoom out
Zoom in
Previous page
1/68
Next page
19
When a decode mode which differs from the type of
disc being played is selected
Insert a DVD disc in the center unit to display the type of audio
being played in the Decode mode indicator in the display window.
Audio cannot be played if a decode mode which differs from the
displayed mode is selected.
The selected decode mode flashes to indicate that the selected
decode mode does not allow audio playback.
Example: When DTS is selected as the decode mode for Dolby
digital audio.
Adjusting the Input Signal Level
When using the DSP mode effect during playback from an analog
device, the sound will occasionally be distorted due to a overly-
strong input signal. In these instances, it is possible to adjust the
level of the input signal. Only input signals from analog devices (TV
SOUND, VCR, TAPE, AUX, FM, AM, MD, DBS) may be adjusted
in this way.
On the front panel only:
1 Press and hold INPUT ATT. (DSP MODE).
Release the button when the display window shows “INPUT
ATT ON,” or “INPUT NORMAL.
Pressing and holding the INPUT ATT. Button further cycles
through the following modes:
INPUT NORMAL: Playback source without adjusting the input
signal level. This is the default setting.
J
INPUT ATT ON: Lower the input level and playback source.
The ATT mark will light up.
To change the input signal level, press and hold INPUT ATT.
until “INPUT NORMAL” or “INPUT ATT ON” is displayed.
Note:
When in “INPUT ATT ON” mode, ATT will light up in the
display window. However, when the playback source is digital
(DVD, etc.) it will go off. Lighting up will resume if playback is
switched to an analog device.
Even while in “INPUT ATT ON” mode, if the DSP mode is
turned off (“DSP OFF”), playback will continue without any
reduction of the input signal.
Basic operations
VOLUME knob
PHASE button
Sub-woofer volume control and
phase setting
Use the VOLUME knob and PHASE button at the rear of the
powered sub-woofer.
Volume control ———————————————
Turn the VOLUME knob.
Adjust to a volume appropriate for balance with the other speaker(s).
The mark indicates the volume position in normal use.
Adjust when the volume from the sub-woofer is too high or too
low in relation to the volume from the front speaker.
Phase setting ————————————————
Play sound through the sub-woofer and adjust the
PHASE button to a position (_ REVERSE or NORMAL)
at which the lowest frequency is heard best.
Note:
Phase is closely related to the distance from the listening position
to the front speaker and sub-woofer.
While listening, adjust until the lowest frequency is heard best.
Audio channel display lamp
Uses lamps to display the audio channel configuration for the disc
currently playing.
The lamps refer to the speaker channel as follows.
L: Left front speaker channnel
R: Right front speaker channel
C: Center speaker channel
RS: Right surround speaker channel
LS: Left surround speaker channel
S: Rear speaker channel (monaural)
LFE: Sub-woofer channel
Mark
Flashes
1
The audio
channel display
lamp is not an
indicator of
which speakers
are producing
sound.
TH-A10[J]2/1 00.2.24, 14:4919
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC TH-A10R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC TH-A10R in the language / languages: English as an attachment in your email.

The manual is 4,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC TH-A10R

JVC TH-A10R User Manual - English - 68 pages

JVC TH-A10R User Manual - Dutch - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info