138393
29
Zoom out
Zoom in
Previous page
1/72
Next page
Masterpage:Right-No-Heading
29
Filename [XV48EK_07S-VHS.fm]
Page 29 November 18, 2004 10:44 pm
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Select the L-2 SELECT mode.
Set “L-2 SELECT” to A/V” or “SAT.” ( pg. 54)
When you select “SAT,” refer to “IMPORTANT” on page 50.
C
Set the tape speed.
Press p.
D
Engage the Automatic Satellite Programme
Recording mode.
On the unit
Press and hold SAT# for
about 2 seconds.
On the remote control
Press and hold REC LINK
for about 2 seconds.
The “N” and “# indicators
light up and the unit turns
off automatically.
NOTES:
Operations on the DVD deck are not possible when the
Automatic Satellite Programme Recording mode is engaged or
timer recording is in progress.
To disengage the Automatic Satellite Programme Recording
mode, press REC LINK. The “N” indicator goes off.
If the unit’s power is off, it is not possible to engage the
Automatic Satellite Programme Recording mode.
In step D, if theN” indicator does not light but instead blinks
quickly even though your satellite receiver’s power is off,
Automatic Satellite Programme Recording will not work
properly with that satellite receiver*. If this is the case, perform
“Express Timer Programming” (
pg. 26) to timer-record a
satellite programme.
* Some satellite receivers output signals even if the power is off.
Automatic Satellite Programme Recording is not possible with those
satellite receivers.
TheN” indicator blinks while Automatic Satellite Programme
Recording is in progress.
For timer programming of the satellite receiver, refer to the
instruction manual of the satellite receiver.
Automatic Satellite Programme Recording is not possible if
your satellite receiver does not have a timer.
Pressing the unit’s 1 button while Automatic Satellite
Programme Recording is in progress turns off the unit’s power
and disengages the Automatic Satellite Programme Recording
mode.
If there are more than one satellite programmes you wish to
record with Automatic Satellite Programme Recording, it is not
possible to set different tape speeds for each programme.
Depending on the type of satellite receiver, the unit may not
record a slight portion of the beginning of the programme or
may record slightly longer than the actual length of the
programme.
If you engage the Automatic Satellite Programme Recording
mode when the satellite receiver’s power is on, the unit will
not start Automatic Satellite Programme Recording even
though the “N” and “#” indicators blink. When the satellite
receiver shuts off once and is turned back on again, the unit
starts recording.
You can also record a programme from your cable system in
the same way if the system has a timer.
The B.E.S.T. system (
pg. 23) does not work while Automatic
Satellite Programme Recording is in progress.
Just Clock (
pg. 65) does not work when the Automatic
Satellite Programme Recording mode is engaged.
Before performing the following steps:
Make sure the satellite receiver is connected to the unit’s
L-2 IN/DECODER connector. (
pg. 50)
Programme the timer on the satellite receiver.
Insert a cassette with the safety tab in place.
Slide the TV/VCR/DVD switch on the remote control to the
right.
XV48EK_01.book Page 29 Thursday, November 18, 2004 10:45 PM
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC hr xv48ex at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC hr xv48ex in the language / languages: English, German as an attachment in your email.

The manual is 3,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info