56729
40
Zoom out
Zoom in
Previous page
1/56
Next page
40 EN
MasterPage: Heading0_Left
TROUBLESHOOTING
If the problem still exists after following the steps below,
please consult your nearest JVC dealer.
Power
The power is not connected properly.
HConnect the AC Adapter securely. ( pg. 7)
The battery is dead.
HReplace the dead battery with a fully charged one.
( pg. 6, 7)
The LCD monitor is not open fully or the viewfinder is not
pulled out when recording.
HOpen the LCD monitor fully or pull out the viewfinder.
If the Record-Standby mode continues for 5 minutes, the
camcorder’s power shuts off automatically.
Then, the POWER/CHARGE lamp will blink to indicate for
charging if the battery pack is attached to the camcorder
and its power is supplied from the AC Adapter.
HPush back and pull out the viewfinder again or close and
re-open the LCD monitor to return to the Record-Standby
mode.
Video and D.S.C. Recording
The Power Switch is set to “PLAY” or “OFF”.
HSet the Power Switch to “A” orM”. ( pg. 11, 18)
— For Video Recording —
The tape’s erase protection tab is set to “SAVE”.
HSet the tape’s erase protection tab to “REC”. ( pg. 10)
The VIDEO/MEMORY Switch is set to “MEMORY”.
(GR-D93/73 only)
HSet the VIDEO/MEMORY Switch to “VIDEO.
“TAPE END” appears.
HReplace with new cassette. ( pg. 10)
The cassette holder cover is open.
HClose the cassette holder cover.
— For D.S.C. Recording (GR-D93/73 only) —
The VIDEO/MEMORY Switch is set to “VIDEO”.
HSet the VIDEO/MEMORY Switch to “MEMORY”.
This is a result of exceedingly high contrast, and is not a
malfunction.
This is not a malfunction.
“DATE/TIME” is set to “OFF”.
HSet “DATE/TIME” to “ON”. ( pg. 24, 27)
This is normal.
Certain Wipe/Fader effects, certain modes of Program AE
with special effects, “DIS” and other functions that cannot
be used together are selected at the same time.
HRe-read the sections covering Wipe/Fader effects,
Program AE with special effects and “DIS”. ( pg. 24 – 31)
16X (10X for GR-D93) optical zoom is selected.
HSet “ZOOM” to “40X” or “700X”. ( pg. 25)
The VIDEO/MEMORY Switch is set to “MEMORY”.
(GR-D93/73 only)
HSet the VIDEO/MEMORY Switch to “VIDEO”.
White spots or bright spots of light (red, green or blue) may
appear on the LCD monitor. This may occur when the
Night-Scope function is activated during recording and is
not a malfunction.
Video and D.S.C. Playback
The Power Switch is set to “A” or “M”.
HSet the Power Switch to “PLAY”. ( pg. 14)
VIDEO/MEMORY Switch is set to “MEMORY”. (GR-D93/
73 only)
HSet the VIDEO/MEMORY Switch to “VIDEO”.
Your TV has AV input terminals, but is not set to its VIDEO
mode.
HSet the TV to the mode or channel appropriate for video
playback. ( pg. 17)
The cassette holder cover is open.
HClose the cassette holder cover. ( pg. 10)
HClean the video heads with an optional cleaning cassette.
( pg. 46)
— (GR-D93/73 only)
The Power Switch is set to “A” or “M”.
HSet the Power Switch to “PLAY”. ( pg. 19)
The VIDEO/MEMORY Switch is set to “VIDEO”.
HSet the VIDEO/MEMORY Switch to “MEMORY”.
The camcorder is a microcomputer-controlled device.
External noise and interference (from a TV, a radio, etc.)
might prevent it from functioning properly. In such
cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and
then re-connect it and proceed as usual from the
beginning.
No power is supplied.
The POWER/CHARGE lamp blinks in the Record-
Standby mode.
Recording cannot be performed.
When shooting a subject illuminated by bright light,
vertical lines appear.
When the screen is under direct sunlight during
shooting, the screen becomes red or black for an
instant.
During recording, the date/ time does not appear.
During recording, sound cannot be heard.
The LCD monitor or viewfinder indications blink.
Digital Zoom does not work.
Coloured bright spots appear all over the LCD
monitor.
Play, Rewind and Fast-Forward functions do not
work.
The tape is moving, but there is no picture.
Blocks of noise appear during playback, or there is
no playback picture and the screen becomes blue.
A memory card cannot be played back.
GR-D93PAL.book Page 40 Wednesday, October 29, 2003 9:36 AM
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-D53 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-D53 in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC GR-D53

JVC GR-D53 User Manual - German - 56 pages

JVC GR-D53 User Manual - Dutch - 56 pages

JVC GR-D53 User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info