56729
39
Zoom out
Zoom in
Previous page
1/56
Next page
REFERENCES
EN 39
MasterPage: Ref_Heading0_Right
ADDITIONAL INFORMATION
Power (pg. 6)
Perform charging where the temperature is between 10°C
and 35°C. 20°C to 25°C is the ideal temperature range for
charging. If the environment is too cold, charging may be
incomplete.
Charging time is based on room temperature of 20°C.
Charging times are for a fully discharged battery pack.
Charging time varies according to the ambient temperature
and the status of the battery pack.
To avoid interference with reception, do not use the AC
Adapter near a radio.
Since the AC Adapter processes electricity internally, it
becomes warm during use. Be sure to use it only in well-
ventilated areas.
The following operation stops charging:
Set the Power Switch to “PLAY”, “A” or “M”.
Disconnect the AC Adapter from the camcorder.
Unplug the AC Adapter from the AC outlet.
Detach the battery from the camcorder.
Using the optional AA-V40 AC Power Adapter/Charger, you
can charge the BN-V408U/V416U/V428U battery pack
without the camcorder. However, it cannot be used as an
AC Adapter.
Loading/Unloading A Cassette (pg. 10)
It takes a few seconds for the cassette holder to open. Do
not apply force.
If you wait a few seconds and the cassette holder does not
open, close the cassette holder cover and try again. If the
cassette holder still does not open, turn the camcorder off
then on again.
If the tape does not load properly, open the cassette holder
cover fully and remove the cassette. A few minutes later,
insert it again.
When the camcorder is suddenly moved from a cold place
to a warm environment, wait a short time before opening
the cassette holder cover.
Closing the cassette holder cover before the cassette
holder recedes may cause damage to the camcorder.
Even when the camcorder is switched off, a cassette can
be loaded or unloaded. After the cassette holder is closed
with the camcorder switched off, however, it may not
recede. It is recommended to turn the power on before
loading or unloading.
When resuming recording, once you open the cassette
holder cover a blank portion will be recorded on the tape or
a previously recorded scene will be erased (recorded over)
regardless of whether the cassette holder came out or not.
See “Recording From The Middle Of A Tape” ( pg. 13).
VIDEO RECORDING (pg. 11)
When you use the LCD monitor outdoors in direct sunlight,
the LCD monitor may be difficult to see. If this happens, use
the viewfinder instead.
The cassette holder cannot be opened unless a power
supply is attached.
There may be a delay after you open the cassette holder
cover until the cassette holder opens. Do not use force.
Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely before
closing the cassette holder cover.
When the Recording Start/Stop button is pressed, it may
take a few seconds before actual recording starts. The “T
indicator starts rotating when the camcorder actually starts
recording.
The time required to calculate and display the remaining
tape length, and the accuracy of the calculation, may vary
according to the type of tape used.
“TAPE END” appears when the tape reaches its end, and
the power goes off automatically if left in this condition for 5
minutes. “TAPE END” also appears when a cassette at its
end is loaded.
VIDEO PLAYBACK (pg. 14)
Clean the video heads using an optional dry cleaning
cassette when:
No picture during playback.
Blocks of noise appear during playback.
For details, pg. 46.
If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to
“OFF”, then to “PLAY”.
You can also view the playback picture on the LCD monitor
with it flipped over and pushed against the camcorder body.
LCD monitor/viewfinder indications:
When power is supplied from a battery: the “
battery indicator is displayed. ( pg. 43)
When power is supplied from an AC outlet: the “
battery indicator does not appear.
When a cable is connected to the AV connector, the sound
is not heard from the speaker.
D.S.C. RECORDING (GR-D93/D73 only) (pg. 18)
Even if “DIS” is set to “ON” ( pg. 25), the Stabiliser will be
disabled.
If Program AE with special effects ( pg. 30) is engaged,
certain modes of Program AE with special effects are
disabled during Snapshot recording. In such a case, the
icon blinks.
If shooting is not performed for approx. 5 minutes when the
Power Switch is set to “A” or “M” and power is supplied
from the battery pack, the camcorder shuts off
automatically to save power. To perform shooting again,
push back and pull out the viewfinder again or close and re-
open the LCD monitor.
The Motor Drive mode ( pg. 31) is disabled when the
VIDEO/MEMORY Switch is set to “MEMORY”.
When a cable is connected to the AV connector, the shutter
sound is not heard from the speaker.
Still images taken are compliant to DCF (Design rule for
Camera File system). They do not have any compatibility
with devices which are not compliant to DCF.
REFERENCES
GR-D93PAL.book Page 39 Wednesday, October 29, 2003 9:36 AM
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-D53 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-D53 in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC GR-D53

JVC GR-D53 User Manual - German - 56 pages

JVC GR-D53 User Manual - Dutch - 56 pages

JVC GR-D53 User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info