20741
105
Zoom out
Zoom in
Previous page
1/112
Next page
Masterpage:Right-No-Heading
EN 105
Filename [DR-M10U_11Subsidiary.fm]
Page 105 March 5, 2004 11:53 am
RECORDING
INITIALIZING
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. The desired program cannot be
recorded.
The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
pg. 26)
2. Recording and editing cannot be
made.
No disc or a disc not being compatible
with the unit is loaded.
Load a recordable disc on the unit.
( pg. 7)
The disc loaded is not formatted. Format the disc. (
pg. 101)
A finalized DVD-R disc is loaded. Recording and editing cannot be made on
finalized discs. ( pg. 102) Load a
recordable disc on the unit.
The disc is full or does not have enough
space for the program to be recorded.
Clear unnecessary programs on the disc or
load a blank disc. (
pg. 77)
The protect tab on the DVD-RAM
cartridge is set to the protect position.
Release the protect tab. (
pg. 11)
3. Timer programing cannot be made. Date and time is not correct. Set date and time correctly. ( pg. 24)
4. Timer programing recording does not
start.
Power failure occurred before the timer
programed recording starts.
Check the timer programing. (
pg. 69)
5. VCR Plus+ Timer Programing cannot
be made.
Date and time set on the unit is not
correct.
Set date and time correctly. (
pg. 24)
The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
pg. 26)
6. Satellite Auto Recording recording
does not start.
The DBS receiver is not connected
properly to this unit.
Connect the DBS receiver to the AUDIO/
VIDEO INPUT (L-1) connector properly.
(
pg. 32)
7. On the front display panel, “– –:– –”
appears.
Power failure occurred. Set date and time correctly. (
pg. 24)
8. “PROGRAM FULL” appears on the TV
screen during timer programing.
Eight programs have already been timer
programed.
Clear unnecessary programs on the unit,
then try timer programing again.
(
pg. 69)
9. The disc space does not increase when
recorded programs are cleared.
The PC’s data recorded on a DVD-RAM
drive cannot be cleared on this unit.
Format the disc. (When the disc is soiled,
wipe the disc with a soft dry cloth before
formatting.) (
pg. 11, 101)
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Malfunction occurs on the unit.
Press 1 to turn off the unit, press and
hold 1, then press 8 for two seconds or
more.
2. The Disc Tray doesn’t open.
Take out the disc in following ways.
Connect and the disconnect the power
cord from the main outlet.
Press and hold the open/close button
(
x) on the unit until the disc tray opens.
(it will take about 30sec.)
Close the disc tray by pressing the open/
close button after taking out the disc.
(the main power shuts down.)
A
TTENTI
O
N:
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc,
operate the unit as usual.
DR-M10U_11Subsidiary.fm Page 105 Friday, March 5, 2004 11:54 AM
105


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC DRM10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC DRM10 in the language / languages: English as an attachment in your email.

The manual is 9,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC DRM10

JVC DRM10 User Manual - German - 116 pages

JVC DRM10 User Manual - Dutch - 116 pages

JVC DRM10 User Manual - French - 116 pages

JVC DRM10 User Manual - Portuguese - 116 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info