20741
104
Zoom out
Zoom in
Previous page
1/112
Next page
Filename [DR-M10U_11Subsidiary.fm]
Masterpage:Left0
104 EN
Page 104 January 16, 2004 7:25 pm
TROUBLESHOOTING
Before requesting service for a problem, use this chart and see if you can solve the trouble yourself. Small problems are
often easily solved, and this can save you the trouble of sending your unit off for repair.
GENERAL
PLAYBACK
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. No power is supplied to the unit. The AC power plug is disconnected from
the mains.
Connect the AC power plug to the mains
securely. (
pg. 18)
2. The channel cannot be changed. Recording or Live Memory recording is
in progress.
Press 9 to pause recording, change the
channel, then press 4 to resume
recording.
3. The Remote does not operate the unit. The setting of the remote control code is
inappropriate.
Set the same remote control code (1, 2, 3,
or 4) on both the unit and the Remote.
(
pg. 91)
The batteries are discharged. Replace the dead batteries with new ones.
4. Dubbing from the external equipment
is not possible.
The setting of the input channel position
is inappropriate.
Select the input channel position (“F-1”,
“L-1”, or “L-2”) that corresponds to the
input terminal connected to the external
equipment. (
pg. 89)
5. The on-screen display superimposed
on the program played back/received
on this unit is recorded when you dub
the program to an external recording
equipment.
Set “SUPERIMPOSE” to “OFF”.
(
pg. 99)
6. The Remote does not work properly.
Remove the batteries, wait for 5 minutes
or more, then load the butteries again.
The batteries are discharged. Replace the dead batteries with new ones.
7. The unit does not operate. There are cases when the operation is
prohibited on the disc.
Lightning or static electricity may cause
malfunction of the unit.
Press 1 on the unit or DVD1 on the
Remote to turn the power off, then press
the button again to turn the power on.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Images do not appear on the TV
screen.
The TV is not set to the AV mode. Set the TV to the AV mode.
When interlace scanned program is
played back, progressive scan mode is
selected.
Press and hold PROGRESSIVE SCAN until
disappears from the front display
panel.
2. Playback dose not start or stop
immediately after playback is started
by pressing 4.
On the front display panel, “NO DISC”
appears.
The disc is loaded upside down. Place the disc on the disc tray with the
playback surface facing downward.
(
pg. 11)
A disc not being compatible with the
unit is loaded.
Load a playable disc on the unit.
( pg. 7, 8)
A dirty disc is loaded. Clean the disc. (
pg. 11)
Defective disc is loaded. Replace the warped or scratched disc with
a normal one.
3. Images are blurred or distorted when
you start High-Speed Search.
Images are blurred or distorted at the point
where the playback speed changes and
this is not a malfunction of the unit.
4. Playback does not start.
Playback does not start for approximately
30 seconds after recording is stopped and
this is not a malfunction of the unit.
5. Playback does not start when you
select a title or a chapter.
The Parental Lock is engaged and the
disc is rated higher than the set level.
Release the Parental Lock temporarily or
change the set level. (
pg. 53)
DR-M10U_01.book Page 104 Friday, January 16, 2004 7:38 PM
104


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC DRM10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC DRM10 in the language / languages: English as an attachment in your email.

The manual is 9,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC DRM10

JVC DRM10 User Manual - German - 116 pages

JVC DRM10 User Manual - Dutch - 116 pages

JVC DRM10 User Manual - French - 116 pages

JVC DRM10 User Manual - Portuguese - 116 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info