656266
31
Zoom out
Zoom in
Previous page
1/41
Next page
PELLET BURNING STOVES
INSTALLATION AND MAINTENANCE MANUAL
31
4. )Safety
POWER FAILURE
After the power failure, the display will be show E7. If short power failure, you can do manually goes back to
"Stabilization" by Clear the E7 by "okay button", restarting the stove and then keeping pressing 3 second of "fire
button"
On power failure a small amount of smoke may be emitted. This does not last for more
than three to five minutes and does not represent a safety risks.
POWER INPUT SOCKET (contains the main fuse)
ELECTRIC EXCESS-CURRENT SHUT OFF
The device is protected against excess current by a main fuse (on the rear of the device),
The following is a list of main components and their functions
IGNITER
The STOVE comes equipped with an automatic igniter for lighting the fuel when the stove is in feeding and lighting mode.
VACCUM SWITCH
The STOVE has s vacuum switch located behind the left door, fastened to the base. If a low pressure is created in the
firebox by a leak, opening the front door, a blocked flue, or unsealed ash drawer(some model), the vacuum switch will
sense it and cause the stove to go into a shutdown mode by showing E5.
AUGER AND AUGER MOTOR
The 2 RPM auger motor turns the auger, lifting pellets up the auger tube. The pellets are then dropped down a tube and into
the firepot. The auger motor is controlled by the control board.
PROTECT TEMPERATURE SENSOR TO AVOIDOVERHEATING
A safety temperature switch switches the stove off automatically if it overheats,. After the stove has cooled down
meanwhile it shows E6. Whether the heating operation is continued or not depends on the remaining embers in the
fire pan. After you remove the Error Code by "Okay button" , If re-ignition does not occur when the fuel supply
recommences, then the out of operation program (cleaning , lag phase) is carried out. According to the pre-set mode
the stove must be re-started.
CAUTION: If overheating has occurred then maintenance or cleaning work must
be carried out.
EXHUASTED TEMPERATURE SENSOR FUNCTION AS LOW TEMPERATURE SWITCH OFF
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Just Fire NB-B18 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Just Fire NB-B18 in the language / languages: English as an attachment in your email.

The manual is 4,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info