725503
16
Zoom out
Zoom in
Previous page
1/22
Next page
14
Operation Method
Refrigeration mode
·
·
·Press the wind speed button to select high, medium or low wind speed.
Fan only mode
.
·Press the wind speed button to select high, medium or low wind speed.
Temperature cannot be set.
Dehumidification mode
·Select dehumidification mode by pressing mode button or
via remote controller, and the dehumidification indicator light
is on.
·When entering dehumidification mode, if the room
temperature is15 (or 59), the compressor will start to
work. Then control according to the following rules: when
room temperature is13(or 55), compressor stops; when
the temperature rises back to 15, the compressor restarts
(the restart of compressor shall meet the 3-minute delay protection function).
·In dehumidification mode, the fan run in low speed by default, and the wind
speed are not adjustable.
·Temperature cannot be set.
(Usage tip: when the dehumidification function is in use, the exhaust pipe
assembly shall be removed; otherwise it will lead to not obvious dehumidification
effect or display FL water full alarm.)
Automatic mode (only for single refrigeration type)
·select automatic mode by pressing mode button or via remote controller, and
automation indicator light is on.
·after selecting the automatic mode, it decides running state based on ambient
temperature: When the ambient temperature is higher than 25, the running mode
is the refrigeration mode; When the ambient temperature is lower than 25, the
running mode is the fan only mode.
After being powered and turned on, its refrigeration mode by default or pressing
mode button to select refrigeration mode, and the refrigeration indicator light is
on.
Press the up or down button to adjust the set temperature (17°C--30°C) .
• Press the mode button or via the remote controller to select fan only mode,
and fan only indicator light is on.
• As shown in the picture below, remove the plug of drainage
cap, insert the aqueduct, and put another end of the
aqueduct into water containers or drain channels.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Just Fire AIRCO9000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Just Fire AIRCO9000 in the language / languages: English as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info