636486
48
Zoom out
Zoom in
Previous page
1/116
Next page
Accessories / Services
6 720 645 817 (2010/09)
48
Fig. 30 Residual head no. 1620
H Residual head
V Flow rate
Fig. 31 Dimensions no. 1620 (dim. in mm)
7.2 Pumps
Size pumps in central heating systems in accordance
with current technical rules.
The sizing of pumps to be used on site depends on the
pressure drop of system and boiler (Æ chapter 2.4,
page 29) and the required pump rate.
7.3 Dirt traps
Deposits in heating systems can lead to local
overheating, noise and corrosion. Any resulting boiler
damage falls outside the warranty obligations.
To remove dirt deposits, flush the new heating system
thoroughly prior to installing and commissioning a
boiler. In addition, we recommend the installation of dirt
traps or a blow-down facility.
Dirt traps retain contaminants and thereby prevent
operating faults in control devices, pipework and
boilers. Fit these near the lowest point of the heating
system in an easily accessible position. Clean the dirt
traps every time the heating system is serviced.
7.4 Low loss header
Subject to the amount of water on the primary and
secondary sides, a lower flow temperature than that
supplied by the boiler itself can be provided if a low loss
header is installed (Æ Fig. 32).
This is the case if the water volume on the secondary
side is greater than that on the primary side. This is used
frequently with gas condensing boilers to prevent a
raising of the return temperature. This leads to a
reduction of the maximum possible flow temperature.
Take this into account when sizing the boiler. For
information, see table 26.
Fig. 32 Use of a low loss header
VF Low loss header sensor
I Primary side
II Secondary side
0
2
4
3
5
6
1
7
0
50
100 150
200
250 300
350 400
V
/ l/min
H
/ m
.
6 720 619 379-56.1O
.
21
Ø12
195
169,5130
82,5
6 720 619 379-57.1O
85 °C
75 °C
60 °C
60 °C
ΔT = 25 K
ΔT = 15 K
VF
III
6 720 643 417-25.1O
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Junkers MKB 400-3 A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Junkers MKB 400-3 A in the language / languages: English as an attachment in your email.

The manual is 15,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info