614754
22
Zoom out
Zoom in
Previous page
1/34
Next page
Adjusting the thread tension
Modo de ajustar la tensión del hilo
Règlage de la tension du fil
The standard bobbin thread tension is such that the bobbin case goes down slowly
when you hold the open end of the bobbin thread and shake it as shown at right. (The
count of the thread is #50.)
* Adjust the needle thread tension in accordance with the bobbin thread tension.
* The bobbin case for the TL-90 Series is an exclusive JUKI part.
Please consult the JUKI dealers when you purchase it.
La tensión estándar del hilo de bobina es tal que el portabobina baja lentamente
cuando usted sujeta el extremo visible del hilo de bobina y lo agita como, o se ilustra
en el lado derecho. (El grosor del hilo es #50.)
* Ajuste la tensión del hilo de aguja en conformidad con la tensión del hilo de bobina.
* El portabobina para la Serie TL-90 es una pieza exclusiva de JUKI.
Cuando vaya a comprar esta pieza, sírvase consultar a los
distribuidores de JUKI.
La tension du fil de canette est normale si la boîte à canette descend lentement
quand on tient l’extrémité libre du fil de canette et qu’on secoue le fil comme sur la
figure ci-contre (fil n° 50).
* Régler la tension du fil d’aiguille en fonction de la tension du fil de canette.
* La boîte à canette pour la série TL-90 est une pièce spéciale JUKI.
S’adresser à un revendeur JUKI pour la commander.
Proper thread tension
Tensión apropiada del hilo
Tension du fil correcte
Improperly adjusted thread tension may cause puckering on
materials, inferior stitches, or thread breakage.
Si la tensión del hilo no está debidamente ajustada se formarán
bultos en el material, puntadas deficientes, o se romperá el
hilo.
Si la tension du fil est mal réglée, il en résultera un froncement
du tissu, des points mal formés ou une cassure du fil.
Center of the material
Centro del material
Milieu du tissu
Needle thread
Hilo de aguja
Fil d’aiguille
Bobbin thread
Hilo de bobina
Fil de bobina
Bobbin thread
Hilo de bobina
Fil de bobina
Needle thread
Hilo de aguja
Fil d’aiguille
Bobbin thread
Hilo de bobina
Fil de bobina
The needle thread tension is too low
La tensión del hilo de aguja está baja
Si la tension du fil d’aiguille est insuffisante
The needle thread tension is too high
La tensión del hilo de aguja está demasiado alta
Si la tension du fil d’aiguille est excessive
Thread tension dial
Perilla de ajuste de tensión del hilo
Bouton du bloc-tension
Increase the needle
thread tension.
Aumenta la tensión del
hilo de bobina.
Augmenter la tension
du fil d’aiguille.
Decrease the needle
thread tension.
Disminuye la tensión
del hilo de aguja.
Diminuer la tension
du fil d’aiguille.
· Adjusting the bobbin case
· Modo de ajustar el portabobina
· Réglage de la boîte à canette
CAUTION:
Turn OFF the power switch when taking out the bobbin case or
replacing the needle.
AVERTISSEMENT:
Avant de retirer la boîte à canette ou de remplacer l’aiguille,
placer l’interrupteur d’alimentation sur arrêt.
AVISO:
Posicione en OFF el interruptor de la corriente eléctrica cuando extraiga
el portabobina o cuando reemplace la aguja.
21
Needle thread
Hilo de aguja
Fil d’aiguille
Tension adjusting
screw
Tornillo de ajuste de
tensión
Vis de réglage de
tension
Increase
Aumenta
Augmentation
Decrease
Disminuye
Diminution
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki TL-98Q at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki TL-98Q in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info