614758
54
Zoom out
Zoom in
Previous page
1/120
Next page
52
Eyelet
punch
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
Clamping plate
1.
Attach the buttonhole presser foot
to the presser foot holder, with the
clamping plate together.
2.
Place the fabric between the presser
foot and the clamping plate.
*
You can remove the clamping plate by holding
A
.
● Buttonhole clamping plate
Stopper
pin
6
Unplug the sensor pin after sewing.
7
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the but-
tonhole with a ripper. Be careful not to cut the stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch. Then pierce a stopper pin
at the bartack and open the buttonhole with a ripper.
Ripper
A
Turn off the power when
setting the clamping plate.
Caution
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki HZL-DX5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki HZL-DX5 in the language / languages: English as an attachment in your email.

The manual is 42,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info