614758
53
Zoom out
Zoom in
Previous page
1/120
Next page
51
4
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through
the hole on the presser foot and pull it out sideways.
Place the fabric under the presser foot, align the mark-
ing with the sewing-start point. Penetrate the needle
into the fabric by turning the hand wheel and lower the
presser foot.
5
Start sewing.
The machine will stop automatically after sewing the
buttonhole.
* If a buttonhole of the same size will be sewn
again, push the thread trimming button to trim
the threads and raise the presser foot.
Under this condition move to another point,
lower the presser foot and then start sewing.
*
Do not change stitch length and/or zigzag width
during buttonholing. Otherwise this will cause
imbalanced stitches.
*
If thread trimming button is pushed while sew
-
ing buttonhole, the machine will stop and will
not complete the buttonhole.
* Depending on material to be sewn and weaving di-
rection of the material, there might be a slight differ-
ence in zigzag widths between right and left lines of
buttonholes. Test sewing is recommended.
Hole on the
presser foot
Sewing-
start point
Needle
thread
Marking
Start from here
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki HZL-DX5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki HZL-DX5 in the language / languages: English as an attachment in your email.

The manual is 42,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info