614555
48
Zoom out
Zoom in
Previous page
1/51
Next page
– 46 –
1. Adjusting the machine head
When the slip between the white marker dot on the handwheel and the concave of the cover is
excessive after thread trimming, adjust the angle of the machine head by the operation below.
IV. MAINTENANCE
1) Turn the power ON while keeping switch
󱀖 and switch 󱀗 held pressed.
"ZAJ" appears on the display section.
2) Turn the pulley of the machine head by hand until
the main-shaft reference signal is detected. At
this time, the degree of an angle from the main-
shaft reference signal is displayed on the display
section A. (The value is the reference value.)
3) In this state, align the white dot of the hand-
wheel with the concave of the cover as shown
in the gure.
4) Press switch 󱀙 to nish the adjustment
work. At this time, the value indicated on display
section A is changed. (The value is the reference
value.)
5) Turn the power OFF.
󱀗
󱀖
Display section A
󱀙
Display section A
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki DDL8700B-7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki DDL8700B-7 in the language / languages: English as an attachment in your email.

The manual is 6,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info