4.7 Aileron to Rudder Mixing (Function Mode)
This form of mixing is designed so that when input to the aileron
stick is given, the rudder servo will also move, eliminating the
need to coordinate these controls manually.
When adjusting, if an opposite mixing direction of the rudder
servo is required, simply press the + or - key and change the
mixing value from + to - or - to +. This will reverse the mixing
direction of the rudder from its original direction.
Mixing Operation and Switches
This mixing program can be turned ON/OFF by a switch. The
switches that can be selected are shown on the chart at right,
with their abbreviations as they appear on the screen and the
corresponding switch positions.
Switch Function
ON Mixing Always ON
MIX Switch ON/OFF Using Mixing Switch
Land Switch ON/OFF Using Landing Switch
ELE>F Switch ON/OFF Using Elevator to Flap Mixing
In the Function Mode, use the UP or DN key to select Aileron to
Rudder Mixing and access by pressing the UP and DN keys
simultaneously.
To adjust, move the arrow to SW with the CH key and select the
needed switch setting using either the + or - key.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
At Rate: Press to
increase or decrease
mixing value
±
125%
At Switch:
Press to change
Switch Selection
Press to
manipulate
arrow from
Rate to SW:
At Rate:
Press to set mixing
value to factory preset
(0%)
At Switch:
Press to set switch to
factory preset (ON)
