700488

JL Audio MHD900 Manual

10
Zoom out
Zoom in
Previous page
1/24
Next page
10 | JL Audio - MHD900/5-24V Owner’s Manual
The output of the amplifier decreases for a
given input voltage when the “Input Range”
switch is placed in the “High” position. The
output increases with the switch in the “Low”
position. While this may sound counter-
intuitive, it is correct as described.
CHANNEL CONTROL SECTIONS
To the left of the “General Setup” section on
the Control Panel of the amplifer are three sets of
controls: one for the “Rear Channel Controls”
one for the “Front Channel Controls” and
one for the “Subwoofer Channel Controls”.
In each of these sections you will find a
rotary control labeled “Input Sens.” (Input
Sensitivity). These controls are designed to match
the input sensitivity of each channel section of
the MDH900/5-24V to the specific signal source
that is feeding the amplifier. These controls must
be adjusted, with care, following the procedures
outlined in this manual. Failure to make correct
adjustments can result in weak output, excessive
distortion and/or undesirable noise in the audio
output of the amplifier!
Note: The Channel Control sections also house
“High-Filter” or “Low-Pass Filter” and “Filter
Freq.” controls. These are crossover filter controls
and will be discussed in the next section of this
manual. This section will explain the Input
Controls only.
“Input Sens.” Controls
Once the appropriate “Input Voltage” range
has been selected in the “General Setup” section
of the amplifier, the “Input Sens.” controls are
used to match the source unit’s output voltage to
the input stage of each pair of amplifier channels
for maximum clean output. Rotating the control
clockwise will result in higher sensitivity (louder
for a given input voltage). Rotating the control
counter-clockwise will result in lower sensitivity
(quieter for a given input voltage). To properly
set each pair of amplifier channels for maximum
clean output, please refer to Appendix C (pages
18, 19) in this manual.
After using this procedure, you can then adjust
the relative level of each channel pair by adjusting
the input sensitivity downward on any of the
channel sections, if they require attenuation to
achieve the desired system balance.
Do not increase the “Input Sens.” setting for
any amplifier or channel section in the system
beyond the maximum level established during
the procedure outlined in Appendix C (pages 18,
19). Doing so will result in audible distortion and
possible speaker damage.
Be aware that all three “Input Sens.”
adjustments will need to be made, regardless
of how many input cables are feeding the
amplifier. These controls will allow you to set
the appropriate relative levels for the “Front”
channels relative to the “Rear” channels and the
“Sub” channel (and any other amplifier channels
in the system).
CROSSOVER CONTROLS
Crossovers are groups of electronic filters
designed to control the frequency ranges
that each speaker in a system will be tasked
with reproducing. Proper crossover setup is
critical to sound quality and reliability.
The MDH900/5-24V has three individually
adjustable filter controls, one for the “Front”
channels, one for the “Rear” channels and
another for the “Sub” channel. The “Front”
and “Rear” filters are high-pass filters (they
attenuate low frequencies), while the “Sub”
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio MHD900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio MHD900 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JL Audio MHD900

JL Audio MHD900 User Manual - English - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info