509308
4
Zoom out
Zoom in
Previous page
1/44
Next page
POWER Amplifiers
2
Features and Specifications
Your new Jensen Power mobile stereo power amplifier is the amplifier of
choice for the high demands of auto sound reproduction. With its deep-bass
reproduction and plenty of reserve power, low harmonic distortion and neutral
reproduction, the Power series of amplifiers takes Mobile Hi-Fi to new heights.
Like all Jensen products, when it comes to accurate sound reproduction the
Power series takes a back seat to no one. Jensen will bring your Hi-Fi
experience to new heights with the following features:
MOSFET Power Supply
High Current Bi-Polar Output Transistors
Optimized Class AB Design Minimizes Distortion and Reduces Idle Current
Easily Drives 2-Ohm Loads
Pass-Thru RCA's
Variable Bass EQ 0 - 12dB @ 45 Hz
12dB / Octave Low Pass and High Pass filters
Variable Input Level 400mV - 5V
Short Circuit, DC-offset and Thermal Overload Protection Circuitry
Diagnostic LED's - Green: Power, Red: Standby / Fault
Power 400.2 / 760.4
Low Pass Filter 40 - 300 Hz
High Pass Filter 40 - 300 Hz
High Pass / Low Pass / Full Range Selector Switch
Stereo / Mono Mode Switch (Power 400.2 only)
2/ 3 / 4 Channel Mode Switch (Power 760.4 only)
Power 900.1
Mono Subwoofer Amp
Low Pass Filter 40 - 240 Hz (Power 900.1)
Subsonic Filter 10 - 40 Hz, 12dB / octave (Power 900.1)
Remote Input Level Control (Remote Bass Control) with 5 Meter Interface
Cable
Specifications
Power 400.2 / 760.4
Load Impedance: 2 / 4-Ohm
Signal to Noise @ 1 kHz: >100dB (rated power)
Channel Separation @ 1 kHz: >60dB
Frequency Response: 5-60 kHz, -3dB
Input Impedance: 20 kHz, nominal
THD+N @ 1 Watt: 0.02%, 1 kHz, 14.4VDC
Power 900.1
Signal to Noise @ 120 Hz: >100dB (Rated Power)
Channel Separation Not Applicable
THD+N @ 1 Watt: 0.02%, 125 Hz, 14.4VDC
Power Output
RMS Power Output @ 2% THD+N, 1kHz, 14.4VDC
Power 400.2
75 x 2 Watts, 4-Ohm
100 x 2 Watts, 2-Ohm
200 x 1 Watts, 4-Ohm Bridged
Power 760.4
75 x 4 Watts, 4-Ohm
100 x 4 Watts, 2-Ohm
190 x 2 Watts, 4-Ohm Bridged Stereo
Power 900.1
300 x 1 Watts, 4-Ohm
450 x 1 Watts, 2-Ohm
Specifications subject to change without notice.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jensen POWER 400.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jensen POWER 400.2 in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info