422470
14
Zoom out
Zoom in
Previous page
1/30
Next page
CHAPTER 6
A m p l i fier Recommendations
No single type of amplifier is specified
for use with the P roject K2 S9800 s y s-
tem. The speakers are highly eff i c i e n t
and will operate adequately with an
amplifier or receiver of 70-100 watts.
H o w e v e r, the transient response and
audio definition of a high-end system
such as P roject K2 S9800 will pick up
all inefficiencies and distortion in an
amplifier system. For full-range opera-
tion, the P roject K2 S9800 s y s t e m
should not be used with an
amplifier/receiver of less than 100
watts. Amplifiers/receivers of 100-500
watts will ensure optimum system per-
f o r m a n c e .
There is no effective limit to the power
handling capabilities of the P roject K2
S9800 loudspeakers when driven by
consumer audio amplifiers. No damage
will occur when used with high pow-
ered components. Source impedance is
an important criteria in selecting an
appropriate unit; the selected amplifi-
er(s) should have a very high current
capacity and must be capable of driving
a low-impedance load.
For bi-wiring or bi-amplification appli-
cations, four identical amplifiers or two
dual-channel units may be used,
although specialized low frequency and
high frequency amplifiers offer clear
advantages. (If four amplifier channels
are used, the high frequency amplifier
may be up to 6 dB less powerful than
the low frequency amplifier. Due to the
power versus frequency distribution of
the music, the low frequency section
requires approximately four times the
power of the high frequency section.)
P roject K2 S9800 specialist dealers can
recommend amplification to best suit
individual needs. In all cases, the left
and right amplifiers for each section
must be identical. Make sure that the
input sensitivity of the two amplifiers is
equal or that input level controls are
provided to maintain the proper low to
mid/high balance. If two identical
stereo amplifiers are chosen, each
amplifier may be located near a loud-
speaker and drive low frequency and
high frequency sections through short
wire runs.
14
Project K2 S9800
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL k2 s9800 s e mahogany hoogglans at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL k2 s9800 s e mahogany hoogglans in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info