650510

JBL Cristalprofi e402 Manual

27
Zoom out
Zoom in
Previous page
1/243
Next page
23
the distance between the surface of the water and the top of the filter must be at least 20 cm
CAUTION: the filter should always be operated in an upright position!
4
Attaching pipes and hoses
Place the intake strainer on the end of the suction pipe and attach it to the inside of the
aquarium using the suction cups and pipe clips. Use long or short clips depending on the
design of the aquarium edge. Pull out the telescopic pipe so that the intake strainer is
about 5 cm above the base of the aquarium. The two parts of the telescopic pipe are sealed
against one another by an O-ring so that no air is drawn into the telescopic pipe, even if the
water level is low (e.g. in a turtle tank).
Connect the water outlet pipe, angle piece and spray bar (if required) and secure them in
the aquarium with suction cups. First, remove the end cap of the spray bar and only replace
it when the filter is operating.
Important note: The plug connections between the parts 8 – 12 and the water outlet pipe
(7) are NOT waterproof. For this reason they are to be positioned INSIDE the aquarium ONLY.
Please ensure that any water leaking from the connections, during operation cannot leave
the aquarium and cause damage to furniture etc.
Tip: We advise against using the spray bar in aquariums containing plants, as too much of
the vital plant nutrient, CO
2
, is expelled from the water. The best results are achieved by
using the water outlet pipe with an angle piece or a wide jet pipe with the outlet just be-
low the surface of the water to produce moderate surface agitation. The distance between
the outlet and the surface of the water can be individually set by using the two extension
pieces.
Connect the hose with the suction pipe from the “IN” position on the hose connection block
(black elbow connection) and the hose with the water outlet pipe from the “OUT” position
(grey elbow connection). Firmly attach the hoses by turning the nuts anticlockwise until
they are tight.
Tip: The installation of a JBL ProFlora Direct inline diffuser into the hose which leads from
“OUT” to the aquarium enables a smart and effective CO
2
supply. Furthermore there will be
no disturbing diffuser inside the aquarium. JBL ProFlora Direct is available as an accessory
at your specialist retailer.
Cut the hoses as short as possible to avoid kinking. This also makes priming easier.
5
Starting up
Make sure that the two small stopcock levers on the pump head are in the “OPEN” position.
During the following start up procedure, the water outlet pipe with the spray bar, etc.
de
en
fr
nl
it
sv
es
pt
pl
cs
ru
ro
tr
el
zh
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL Cristalprofi e402 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL Cristalprofi e402 in the language / languages: All languages as an attachment in your email.

The manual is 4,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info