602029
79
Zoom out
Zoom in
Previous page
1/81
Next page
77
The LCD screen shows an abnormal display.
Power switch is turned on while depressing
the foot control.
The machine is malfunctioning due to a
problem in its electronic components.
The foot control is disconnected while sewing.
The start/stop button is pressed after the foot
control has been connected.
Turn OFF the power and
connect the foot control.
Disconnect the foot control
and restart the machine.
Release the foot control.
Contact the service center or
the store from where the
machine was
purchased.
Turn the power switch
off and turn it on
again.
Audible Signals
BEEP Beep sounds during:
pip
pip-pip-pip
Normal operation
Invalid operation
Message Problem/Cause
Remedy
to
F1 ERROR
The sub needle plate mechanism fails to
operate properly.
Raise the presser foot and turn
the power switch off.
Clean the hook area, then turn
the power on again.
It is normal that a faint humming sound is coming out from the internal motors.
79


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 5200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 5200 in the language / languages: English as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info