602029

Janome Memory Craft 5200 Manual

78
Zoom out
Zoom in
Previous page
1/81
Next page
76
Warning Messages
Message Problem/Cause
If a buzzer sounds and the LCD screen shows one of these messages, follow the guidance below.
• The machine will stop after several stitches if the
buttonhole is sewn without lowering the
buttonhole lever.
• The machine is started with the presser foot up.
• The machine will stop if the presser foot is raised
while sewing.
• The machine is stopped while sewing a locking
stitch.
• The twin needle button is pressed when a pattern
unsuitable for twin needle sewing has been
selected.
• An unsuitable pattern is selected when the twin
needle mode has been activated.
Lower the presser
foot and start the
machine again.
Lower the buttonhole
lever and start the
machine again.
Cancel the twin needle
mode, and sew with a
single needle.
Sew until it automatically
stops.
Remedy
• The machine is started soon after it has
halted due to overloading.
• Bobbin winder spindle locks during bobbin
winding.
Wait for at least 15
seconds to restart.
If thread jamming causes
overload, remove the
tangled threads.
Turn off the power and
remove tangled thread.
• The machine is turned on when the needle is in
the down position.
Press the up/down needle
position button to raise the
needle.
• The machine is turned on when the needle is in
the down position and the bobbin winder spindle
is shifted to the left.
Turn the hand wheel to
raise the needle.
• The elongation button is pressed when a pattern
that cannot be elongated has been selected.
• The memory button is pressed when a pattern that
cannot be programmed has been selected.
Select satin stitches to
be elongated.
Select the equivalent
patterns from mode 2.
… 78 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 5200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 5200 in the language / languages: English as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info