472831
15
Zoom out
Zoom in
Previous page
1/43
Next page
13
w
e
Threading the Machine
Threading the machine
q Up/down needle position button
w Spool
* Raise the thread take-up lever to its highest position.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off as shown.
z Draw the end of the thread around the upper thread
guide.
x While holding the thread near the spool w, draw the
end of the thread down around the check spring holder.
c Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
v Pass the thread through the lower thread guide. Slide
the thread behind the needle bar thread guide on the
left. Thread the needle from front to back, or use a
needle threader.
zx
cv
q
zx
cv
w
zc
x
v
q
r
w
t
NOTE:
The needle threader can be used with a #11 to #16
needle or a blue tipped needle. Thread size 50 to 90
should also work well.
Needle Threader
q Knob
w Hook
e Guide (a)
r Guide (b)
t Holder plate
z Lower the presser foot. Raise the needle to its highest
position. Pull down the needle threader knob q as far
as it will go. The hook comes out through the needle
eye from behind.
x Draw the thread from guide (a) e to guide (b) r and
under the hook w. Draw the thread up along the right
side of the guide (b) r and slip the thread in between
the guide (b) and the holder plate t.
c Raise the knob in the direction of the arrow on the
illustration, drawing the thread loop through the
needle.
v Pull the thread through the needle eye.
CAUTION:
Turn off the power switch when using the needle
threader.
15


Need help? Post your question in this forum.

Forumrules
1

Forum

janome-dc4030

Reset search

  • i just got a janome model DC4030PR is the same as the DC4030 thanks Submitted on 30-1-2024 at 01:14

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome DC4030 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome DC4030 in the language / languages: English as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Janome DC4030

Janome DC4030 User Manual - Dutch - 43 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info