658894
60
Zoom out
Zoom in
Previous page
1/98
Next page
MAINTENANCE & ADJUSTMENT
59
FIG. 5-14
FIG. 5-15
LUBRICATION DETAILS
Grease Fittings
Lubricate all grease fittings (refer to Fig. 5-1) every 50
h of operation using multipurpose lithium base grease.
Clean grease gun and fittings before and after greas-
ing to prevent contamination from dirt.
NOTE: When operating in muddy or extremely wet
conditions, daily lubrication of fittings is
recommended.
Engine Oil Filter
Engine oil and filter should be changed after first 50h
of operation and then every 150h thereafter.
FIG. 5-14: To Check Engine Oil Level - Tractor must
be parked on level ground with engine off. Pull out
dipstick, 1, and check that oil level is between upper
limit, F, and lower limit, L, on dipstick. Wipe off dip-
stick, momentarily reinstall in engine and check oil
level again.
Add oil through filler opening, 2, as required.
NOTE: Add oil slowly to assist in venting air from
crankcase.
FIG. 5-15: To Change Engine Oil - Operate Tractor
until oil is adequately warmed. Remove drain plug,
1, from engine and allow all oil to drain. Reinstall
drain plug and fill engine crankcase to upper limit on
dipstick.
To Replace Engine Oil Filter - Unscrew element,
2, from engine and discard. Make sure original filter
gasket has been removed. Lubricate new gasket on
replacement element with clean engine oil. Screw on
new element until gasket contacts adapter and then
tighten element 1/2 turn more.
Clean spilled oil and refill crankcase. Start engine,
check for leaks and replenish oil level as required.
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Iseki TXG237 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Iseki TXG237 in the language / languages: English as an attachment in your email.

The manual is 10,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info