658894
43
Zoom out
Zoom in
Previous page
1/98
Next page
TXG237
42
Rear PTO Shaft
FIG. 4-10: A 6-spline 1 3/81(35mm) PTO shaft, 1, is
provided at rear of Tractor to provide power for mount-
ed and other PTO driven equipment as required.
A protective cover is positioned over shaft splines
when not in use.
Normal rear PTO shaft operating speed of 540 rpm is
attained at 2532 engine rpm.
IMPORTANT: When rear PTO is used with 3-point
mounted equipment, it may be neces-
sary to remove drawbar, 2, at rear of
Tractor.
Some types of mounted equipment,
when lowered, may allow PTO shaft to
contact drawbar.
FIG. 4-11: Implement drive shaft shown connected to
Tractor rear PTO shaft.
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Be-
fore cleaning or adjusting Tractor or PTO
driven machine, SHUT OFF ENGINE AND
DISENGAGE PTO.
Mid PTO Shaft
FIG. 4-12: Mid PTO, 1, is forward-facing shaft lo-
cated at underside of Tractor. The mid PTO is used
to operate certain mid or front-mounted implements.
A1”(25.4mm) 15 spline shaft is used.
Mid PTO cover must be installed when use of mid
PTO is not required.
2000 rpm @ 2476 engine rpm
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Be-
fore cleaning or adjusting Tractor or any
PTO driven machine, SHUT OFF ENGINE
AND DISENGAGE PTO.
1
FIG. 4-10
FIG. 4-11
FIG. 4-12
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Iseki TXG237 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Iseki TXG237 in the language / languages: English as an attachment in your email.

The manual is 10,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info