737419

Inventum VFI6042 ZWA Manual

39
Zoom out
Zoom in
Previous page
1/56
Next page
English • 39
AUTOMATIC OPERATION
Use this function if the oven is to be switched on for a specified period of time and switched off
at a fixed hour.
Set the preparation time and the end time.
Example: the current time is 11:00. The cooking time is 1 hour. The dish has to be done by 14:00.
The oven starts cooking at 13:00 (14:00 minus 1 hour) on the preset temperature and oven
function and will finish at 14:00.
• Press the [ OK ] key until the display shows dur and the
symbol flashes.
• Set the required preparation time using the keys [ < ] or [ > ].
• Press the [ OK ] key repeatedly until the display shows End and the symbol flashes.
• Set the switch off time (preparation end time) using the keys [ < ] or [ > ]. The end time is
limited to a period of 23 hours and 59 minutes.
• Set the oven function knob and the temperature knob to the setting at which you want the
oven to operate. Both symbols and are now active. Automatic operation has been set
• Once the preparation time has elapsed the oven will turn off automatically. You will hear an
alarm and the symbols
and will be flashing.
• Press and hold any key to mute the alarm. The symbols and will be off and the display
will show the current time after approximately 7 seconds - i.e. 14:02.
• Turn the knobs for the oven function and the temperature to the off setting [ 0 /
].
CANCEL SETTINGS
The timer and the automatic function settings may be cancelled at any time.
• Press the keys [ < ] and [ > ] simultaneously to cancel the automatic function settings.
• Press the [ OK ] key to select the timer settings and then press the keys [ < ] and [ > ] simultaneously to cancel the timer.
CHANGE THE TONE OF THE ALARM SIGNAL
The tone of the alarm signal may be changed as follows:
• Press the keys [ < ] and [ > ] simultaneously.
• Select with the [ OK ] key the function ton. The display will flash.
• Select with the key [ > ] the desired tone in the following order: ton 1, ton 2 or ton 3
or
• select with the key [ < ] the desired tone in the reverse order: ton 3, ton 2 or ton 1.
OK
OK
OK
OK
OK
ADJUSTING THE BRIGHTNESS OF THE DISPLAY
You can adjust the brightness of the display in the range of 1 to 9, where 1 is the darkest and 9 is
the brightest. The brightness setting applies to an inactive control panel, i.e. when none of the
controls are used 7 seconds.
• Press the keys [ < ] and [ > ] simultaneously.
• Press the [ OK ] key repeatedly to select the bri setting. The settings can be accessed in
sequence ton (tone) and bri (brightness).
• Select the desired brightness with the key [ > ] in the following order: 1 to 9
or
• select the desired brightness with the key [ < ] in the reverse order: 9 to 1.
Note: The display is at its brightest setting when active, i.e. a control was touched within the last 7 seconds.
OK
NIGHT MODE
The display is dimmed during the night hours: 22:00 - 6:00.
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum VFI6042 ZWA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum VFI6042 ZWA in the language / languages: English, Dutch as an attachment in your email.

The manual is 14,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Inventum VFI6042 ZWA

Inventum VFI6042 ZWA User Manual - German, French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info