694996
29
Zoom out
Zoom in
Previous page
1/92
Next page
before first use
3
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Check that the voltage in your home corresponds with the voltage
printed on the bottom of the appliance and plug it in a socket. Follow the installation instructions in chapter INSTALLATION
for installing the cooker.
Clean the cooker and all the accessories with warm water and a mild cleaning detergent. Rinse well and dry thoroughly.
Operate the oven for about 30 minutes at the maximum temperature to burn off all traces of grease which might otherwise
create unpleasant smells when preparing food.
installation
4
The following instructions are addressed to the qualified specialist installing the cooker. These instructions aim at ensuring
that installation and maintenance activities are performed as professionally as possible.
Ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance
are compatible before installing the cooker.
The adjustment conditions are stated on the rating label.
This appliance is not connected to a combustion products evacuation device. It shall be installed and connected
in accordance with current installation regulations. Particular attention shall be given to the relevant requirements
regarding ventilation.
INSTALLING THE COOKER
The kitchen should be dry and well ventilated and have effective ventilation according to the existing technical
provisions.
The room should be equipped with a ventilation system that pipes away exhaust fumes created during combustion.
This system should consist of a ventilation grid or hood. Hoods should be installed according to the manufacturer’s
instructions. The cooker should be placed so as to ensure free access to all control elements.
The room should also enable the necessary air supply for proper gas combustion. Air supply should be not less than
2m
3
/h per 1 kW of burner heat. The air can be delivered from outside by a duct with a section of at least 100cm
2
, or
indirectly from adjoining rooms which are fitted with ventilation ducts leading outside.
If the appliance is used intensively and for a long time, it may be necessary to open a window in order to improve
ventilation.
In terms of protection against the overheating of surrounding surfaces, the gas cooker is an X – class appliance and can
be built into furniture only up to the level of the cooking hob, that is around 850 mm above the floor. Raising furniture
construction over this level is inadvisable. Coating or veneer used on fitted furniture must be applied with a heat resistant
adhesive (100°C). This prevents surface deformation or detachment of the coating. If you are unsure of your furniture’s
heat resistance, you should leave approximately 2 cm of free space around the cooker. The wall behind the cooker
should be resistant to high temperatures. During operation, its back side can warm up to around 50°C above the ambient
temperature.
The cooker should stand on a hard, even floor (do not put it on a base).
HOOD
min. 600 mm
min. 420 mm
min. 420 mm
min. 700 mm
English 29
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum VFG6034 WG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum VFG6034 WG in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info