Manual Inventum BM90 (page 36 of 44) (English, German, Dutch, French, Portuguese)

49516

Zoom out

Zoom in

1/44

12: Bake With this program you can bake-off

ready-made-dough. This program is only

for baking. The program is preset at 60

minutes. Follow the instructions on the

package of the ready-made-dough. You

can also heat up a baked bread.

Step 1: Open the lid and remove the breadpan by

turning it a quarter to the left and pull it

straight up with the handle.

Step 2: Place the kneading blade on the drive shaft

in the middle of the breadpan. If the

kneading blade is not seated correctly,

ingredients may not be mixed and kneaded

properly. Before inserting the kneading

blade ensure that there are no crumbs

attached to the shaft inside the breadpan or

inside the hole in the kneading blade.

Step 3: Put the ingredients into the breadpan in the

following order:

    1.Firsthalfoftheour

2. Water/milk

3. Butter/oil

4. Eggs - if necessary

    5.Theremainingour

6. Sugar (place the sugar on one side)

7. Salt (place the salt on the other side)

8. Yeast (place the yeast in the center)

Attention: The yeast may not come in

contact with the water. The possibility exists

that the water will activate the yeast before

the ingredients are kneaded properly.

Step 4: Wipe down the outside of the breadpan to

remove spillage. Place the breadpan in the

breadmaker and turn it a quarter to the right

    makingsurethebreadpanstandsrmlyinto

position.

Step 5: Close the lid.

Step 6: Put the plug into a socket. The display shows

“3:00“.

Step 7: Select the right program with the Menu-

button.

Step 8: With the Crust-button you can select the

colour of the crust. You can select light (L),

medium (M) or dark (D). The selected crust

will be shown at the top of the display with a

“∆“.

Step 9: With the Grams-button you can select the

right size of bread you wish to make, 750 or

900 grams. The selected size will be shown at

the top of the display with a “∆“.

Step 10: Set the timer with the timer-buttons (+/–).

See also: “How to use the preset timer”.

Step 11: Press the Start-button. The colon will now

blink, indicating that the program is

activated.

* If you select one of the following programs, you cannot

select a size: Fast, Superfast I, Superfast II, Dough, Jam,

Cake and Bake. See also the chapter “Recipes”. You can

ndanoverviewoftheexacttimesonthelastpageof

the English manual.

8 | BAKING BREAD

The time which is shown in the display is given in

hours and minutes. For example: Program 1, Normal,

crustcolour medium, 750 grams takes 2 hours and 53

minutes.

During the kneadingprocess a "beep-signal" sounds: after

this "beep-signal" you can add extra ingredients such as

dried currants, nuts or other products. Open the lid, add

the ingredients, close the lid and the kneadingprocess will

proceed. Attention: Let currants, raisins and nuts steep

before adding and dry them with a kitchen towel. Make

sure that the ingredients are not too large or too sharp,

otherwise they can damage the non-stickcoating of the

breadpan.

Step12: Whenthebreadisnishedbaking,the

breadmaker will sound double “beeps“ and

display will read “0:00“. Press the

stopbutton and hold it for several seconds.

The breadmaker will beep again to conrm

that you have de-activated the program.

Unplug the breadmaker and open the lid.

Remove the breadpan with ovenmitts as it is

very hot! Leave the bread in the breadpan to

cool off for 10 to 15 minutes. Turn the

breadpan upside down and shake to loosen.

Never place the bread and the breadpan on

the outside of the breadmaker or on a plastic

tablecloth. Attention: the aluminum

breadpan can not stand beating, knocking

on the counter and pushing and/or

squeezing on the sides. After baking the

hot breadpan is weak and must not be

loaded on mechanically.

When the bread does not loosen immediately,

carefully turn on the bottom of the

driveshaft until the bread loosens.

If you remove the bread from the

breadmaker and the kneading blade stays in

the bread, carefully remove it.

Leave the bread to cool on a wire rack and

remove the kneading blade afterwards with

    yourngers.Makesurethatthe 

kneadingblade is cooled down. It is

recommendable to cut the bread after 15 to

20 minutes.

Extra: If you do not wish or are not able to remove the

bread immediately, the breadmaker will automatically go

into a “keep warm“ setting, holding the temperature of

the bread for up to 60 minutes. This is not included in the

total time of the program.

If you wish to use the timer, you must set the timer

before you press the Start-button.

Important: do not use the timer if you use perishable

ingredients.

Followtherst9stepsofthechapter“Bakingbread“,

then; after you have selected the right program, the right

crust colour and the right size, press on the timer-buttons

to increase or decrease the time on the display. See the

chapter “The display”.

+ = 10 minutes to

— = 10 minutes off

9 | HOW TO USE THE TIMER

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Inventum BM90 in the language / languages: English, German, Dutch, French, Portuguese as an attachment in your email.

The manual is 0,54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Inventum BM90 Manual

Product: