550038
8
Zoom out
Zoom in
Previous page
1/18
Next page
192
A
S AVE THESE INSTRUCTIONS
(192IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
Page 8
PRODUCT SPECIFICATIONS
SET UP
Maximum seating capacity: 4 adults
Water capacity: 210 gal (795 L)
Inner/outer diameter: 58/75 in (147/191 cm)
Height: 28 in (71 cm)
Bubble air blower: 0.9HP / 220-240 V / 50 Hz
Filter pump ow rate: 400 gal/hr (1,514 L/hr)
Heater power: 2,200 Watts / 220-240 V / 50Hz
Temperature range: 20ºC – 40ºC (68ºF – 104ºF)
Temperature rise: 1.5-2.5ºC/hr (3ºF – 4.5ºF/hr)
Number of Bubble Jets: 120
Spa tub recommended working air pressure: 0.083 bar (1.2 psi)
Cord-connected spa with pump, heater, blower and control panel.
SAFETY ZONE REQUIREMENTS
The spa electrical appliance must be installed in Zone 1, 2 or outside all zones. The measured zones are limited by walls and
xed partitions.
1.5m 1.5m2.0m 2.0m
2.5m
2.5m
h
h
Zone 2
Zone 1
Zone 0
Zone 0
Zone 2
Site preparation and requirements
The spa can be installed indoor or outdoor. For household use only.
The spa must be setup on a level, at and smooth surface that is capable of supporting the maximum load of the lled
spa with four adult occupants; weight 1136Kg (2500 lbs).
Make sure the area is free of sharp objects under or around the spa.
Provide adequate drainage system around the spa to deal with over ow water and splashes.
Provide a properly located power outlet to connect the spa and allow easy access for periodic testing of the cord
mounted GFCI/RCD.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance and/or
service.
The area shall facilitate draining purposes during long term spa storage.
Additional requirements for indoor installation
Make sure the oor can support the full weight of the lled spa with the maximum number of occupants. Check with a
quali ed contractor or a structural engineer to verify this requirement.
Make sure the oor is water resistant and non-slip surface. Do not install the spa on carpet or other materials that will be
damaged by moisture, condensation.
Do not install the spa indoors on a second oor above nished living space due to the possibility of water and humidity
damage.
Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow moisture to
escape. Install a ventilating system to prevent excess condensation, moisture in the room.
Additional requirements for outdoor installation
Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers, lighting, and
other safety requirements. Contact your local building code enforcement of ce for further details.
Make sure the surface is level, at, smooth and strong enough to support the full weight of the lled spa.
Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage the spa oor.
Do not expose the spa to direct sunlight for extended period of time.
It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the water
temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system, pump, pipe are not
frozen. Put a “temp barrier mat” between the spa oor and the ground to prevent heat loss from the bottom of the spa
and to provide better heat retention.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex Pure Spa at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex Pure Spa in the language / languages: English as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Intex Pure Spa

Intex Pure Spa User Manual - German - 24 pages

Intex Pure Spa User Manual - Dutch - 19 pages

Intex Pure Spa User Manual - French - 21 pages

Intex Pure Spa Additional guide - All languages - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info