686151

Intex ECO7111 Manual

11
Zoom out
Zoom in
Previous page
1/29
Next page
SAVE THESE INSTRUCTIONS
Page 2
(249PO) MODEL ECO7111 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 05/25/2016
English
249
PO
S AVE THESE INSTRUCTIONS
English
Page 11
SALT & POOL WATER VOLUMES
• Whichkindofsalttouse:
Use only Sodium Chloride Salts
Useonlysodiumchloride(NaCl)saltthatisatleast99.8%pure.Itisalsoacceptabletouse
water conditioning salt pellets (the compressed forms of evaporated salt). However, it will take
a longer time for them to dissolve.
Do not use iodized or yellow (yellow prussiate of soda)
colored salt.
Salt is added to the pool water and the electrolytic cell uses this salt to create the
sanitizer. The purer the salt the better the performance of the electrolytic cell.
• OptimumSaltLevels
Theidealsaltlevelinthepoolwaterisbetween2500-3500ppm(partspermillion).Theoptimal
levelis3000ppm.
A too low salt level will reduce the efficiency of the saltwater system and result in low sanitizer
production. A high salt level may generate a salty taste to the pool water (this may occur at a salt
levelabove3500-4000ppm).Toohighofasaltlevelmaydamagethepowersupplyandcause
corrosion to pool metal fixtures and accessories. The Salt Table page of this manual, shows the
correct dosage of salt needed. The salt in the pool is constantly recycled. Salt loss occurs only
when pool water is physically removed from the pool. Salt is not lost due to evaporation.
• AddingSalt
1.
Switch on the unit, then press and hold both and button for 5 seconds, the LED
flashes “FP”. The unit is now in a Filter pump working mode and switch the filter pump on to
start the water circulation.
2.
Keep the saltwater system turned off.
3.
Determine the amount of salt to be added (see “Salt Table”).
4.
Evenly spread the proper amount of salt around the inside perimeter of the pool.
5.
Avoid clogging the filter by not adding salt through the skimmer.
6.
Brush the pool bottom to speed up the dissolving process. Do not allow salt to pile up on the
bottom of the pool. Run the filter pump 24 consecutive hours to thoroughly dissolve the salt.
7.
After 24 hours and if all the salt is dissolved, turn on the Saltwater System, press button
until you hear a “beep”, code “00” flashing (see “System Operation” section steps 2 to 4) and
set the saltwater system to desired operating time (see “Operating Time Table”).
• RemovingSalt
If too much salt has been added, the unit will beep and display “code 92” (see “Alarm Codes”).
You will need to lower the salt concentration. The only way to do so, is to partially drain the pool
andrefillitwithfreshwater.Drainandrefillapproximately20%ofthepool’swateruntilthe“Code
92” disappears.
• PoolVolumeCalculation
Rectangular
Length x Width x Average Depth x 7.5 Length x Width x Average Depth
Circular
Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79
Oval
Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80
Types of Pool
Gallons
(pool size in feet)
Cubic Meters
(pool size in meters)
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex ECO7111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex ECO7111 in the language / languages: English as an attachment in your email.

The manual is 5,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info