752348
34
Zoom out
Zoom in
Previous page
1/38
Next page
(159) MODEL CS20110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 07/18/2012
159
SAVE THESE INSTRUCTIONS
Page 34
English
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE (continued)
INSUFFICIENT
CHLORINE
INSUFFICIENT
COPPERION
LEVEL
POOLISSTAINED
WHITEFLAKESIN
THEWATER
NOLEDDISPLAY
GREENHAIR
Without cyanuric acid.
• Insufficient operating hours of
the Saltwater System.
• The salt level in the pool water
is less than 2000ppm. This is
insufficient.
• Chlorine loss due to intense
sunlight exposure.
• The bather load has increased.
• Clogged or dirty electrolytic cell.
• HighUVlevelexposure.
• Insufficient operating hours.
• The PHistoohigh.
• The bather load has increased.
• Clogged or dirty electrolytic cell.
• Copper electrode defective.
• Highcopperionconcentration.
• Excessive calcium hardness is
present in pool water.
Nopowersupply.
• RCD/GFCIhasnotreseted.
• A power fuse has blown.
• LED failure.
• Highcopperionconcentration.
• See “Cyanuric acid table”.
•
Increase the daily Saltwater System
operating time. See “Operating Instructions”.
CheckthesaltlevelwiththeTestKit.Adjust
asneeded.See“Salt&PoolWaterVolumes”.
Use a pool cover when the pool is not in use
and/or when the unit is operating.
Increase the daily Saltwater System operating
time. See “Operating Instructions”.
Remove the cell for inspection, clean it if
necessary. See “Maintenance”.
• Coverthepoolwithapoolcoverfor2dayswith
the device running and then test the water
using the test strips.
• Ifthepooliscleanandclear,addstabilizerto
the water and then test the water.
Increase operating time per day. See
“Operating Instructions”.
UsePHdecreasechemicaltoadjust,
contact your local pool chemical store.
Increase the operating time per day.
See “Operating Instructions”.
Remove the cell for inspection, clean it
if necessary. See “Maintenance”.
Contact Intex Service Center.
•
Drainabout20%ofthepoolwaterandadd
fresh water to decrease the copper ion
concentration below 0.2ppm.
Add aluminum sulfate: 1000 liters water need
around 2g (1000 gals need 0.27 ounce) or
aluminum potassium sulfate: 1000 liters water
need around 3g (1000 gals need 0.4 ounce)
to pool.
Use a lemon based cleaning product
(preferably containing citric acid). Don’t scrub
with aggressive cleaning products because
this might etch the underlying surface.
Drainabout20to25%ofthepool
water and add fresh water to decrease
the calcium hardness. Inspect the
electrolytic cell for scale buildup. Clean
the electrolytic cell if necessary.
Plug the cell cord firmly into the cell
housing receptacle.
ResettheRCD/GFCI.
Contact Intex Service Center.
Contact Intex Service Center.
• Drainabout20%ofthepoolwaterand
add fresh water to decrease the copper
ion concentration below 0.2ppm.
• Add aluminum sulfate: 1000 liters
water need around 2g (1000 gals need
0.27 ounce) or aluminum potassium
sulfate: 1000 liters water need around
3g (1000 gals need 0.4 ounce) to pool.
Use ‘Ultra-Swim’ shampoo, or shampoo
containing chelating agents.
PROBLEM CAUSE SOLUTION
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex CS20110 Krystal Clear at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex CS20110 Krystal Clear in the language / languages: English as an attachment in your email.

The manual is 12,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info