Manual Innova 2.0 (page 9 of 28) (English)

688780

Zoom out

Zoom in

1/28

1.9

1.10

1.11

USER MANUAL

Suggestions for power saving

Diagnosis of problems

- Always keep the filters clean (see maintenance and

cleaning chapter).

- Keep the doors and windows of the rooms to be air

conditioned closed

Do not let direct sunlight to enter the room (use

curtains or lower the blinds or close the shutters)

- Do not block the air flow paths (input and output)

of the unit; this, as well as causing a non-optimal

performance of the unit, will jeopardise the correct

operation of the same and may cause irreparable

damage to the units.

For the User it is very important to distinguish any

inconveniences or abnormal operation of the unit

compared to its normal operation. Also, the most

common problems can be easily solved by means of

simple operations performed by the User (See paragraph:

Troubleshooting), while for some alarms signalled on the

display, it is necessary to contact Customer Service.

We also remind you that any attempt to repair the unit on part

of unauthorised technicians will void the warranty immediately.

- The compressor will not restart before a certain time has

passed (about three minutes from the previous stop). It is

not possible to stop and restart the compressor without

waiting at least three minutes. This is provided for in the

operating logic of the unit, so as to protect the compressor

from frequent activations.

- During operation in heating mode, the warm air is delivered

a few minutes after the activation of the compressor. If the

fan started at the same time as the compressor, in the first

minutes of operation the air delivered would be too cold

(which may disturb the occupants of the room) since the

unit is not yet ready.

If the remote control has been lost, the batteries are exhausted or it

no longer works, the unit can be operated by using the keys on the

touch screen display on the machine.

Operating aspects that should not be interpreted as problems

Season change procedure

Using the unit if the remote control is not available

Should any anomaly occur in the condensation water

system, the maximum level float blocks the conditioner

and the OF code appears on the display.

During cooling and dehumidification, electronics keeps the

water distribution system active with the battery - together

with the fan - to disperse excess water in the container.

If the problem persists, please contact the assistance

service.

During heating, condensation should drain freely through

the specific pipe. In the event of an alarm, check that

the condensation pipe is not bent or obstructed, thus

preventing the water from flowing out.

Note: At the end of the summer season empty the residual

condensation by opening the cap of the condensation

drainage pipe.

Evacuation of condensate water in the event of an emergency

If the presence contact is not closed, the appliance will

not start and the CP alarm appears on the display.

Open CP contact

Note: When installing the nebulizer 3.0 it's very important

to follow the indicated procedure to avoid a systematic

alarm and the possible failure of the nebulizer.

This procedure, enabled through the display of the air

conditioner ..2.0, modifies the default settings of the drain

pan of the appliance by disabling its automatic closure

during the summer season. This procedure is used to

avoid that during the summer season, with the opening

of the drain valve of the drain pan, the condensate itself

is poured all in the 3.0 nebulizer installed under the

appliance.

To activate this function:

- Press the cooling mode key on the display of the ..2.0

for 15 sec.

- The symbol “En” will appear

- Press again for 15 sec. the key

- The symbol “ds” will apppear

- Let the display go back to the main screen

The condensate drain will always remain open in both

seasons, guaranteeing a regular flow of condensation.

Configuration with the nebulizer 3.0

i need a simple instruction on hoe to operate the remote control for the innova2.0vertical 10-12DC Inverter A/C unit this is for a nursing home where the residents need the simple example please help i checked the operators manual and its to much for them to comprehend thanks Submitted on 15-7-2022 at 15:49
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Innova 2.0 in the language / languages: English as an attachment in your email.

The manual is 6,35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Innova 2.0

Innova 2.0 Installation Guide - English - 20 pages

Innova 2.0 User Manual - Dutch - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Innova 2.0 Manual

Product: