688781
12
Zoom out
Zoom in
Previous page
1/20
Next page
12
S
I
U
A
B
PARETE LATO
INTERNO
INSIDE WALL
PARETE LATO
ESTERNO
OUTSIDE WALL
C
A
B
C
2.6
INSTALLATION
Junction line
Hook
Flap in ventilation position
Once the holes have been made, place the supplied
plastic sheets inside them.
Roll up the sheet and insert it in the hole, checking that the
A junction line is aiming upwards. Use a cutter to remove
any excess pipe.
To place the external grids, proceed as follows:
- connect the chains to the ends of the springs;
- fold the external shutters;
- insert your arm in the hole to push the shutter outside
while holding the ends of the chains with the other
hand to prevent them from falling down;
- open the shutter inside the hole;
- rotate the shutter to bring the flap in the vertical C
position and check that the closing mechanism works;
- pull the chains by tensioning the springs;
- use a bolt cutter to remove any excess chain.
- anchor the hook of the chain to wall B.
Use only the supplied grids or grids with the same
characteristics.
The shutters must be positioned with the flap in
vertical.
The shutters are different. Should be distinguished
from that position on the recovery from the one place
on the delivery, according to the opening direction of
the fins.
Once installation of the grilles is complete check their
opening (towards the inside of the duct for the air inlet
grid "IN" and towards the outside of the duct for the air
outlet grid "OUT"). Remember that the grilles open when
the external air flow is activated, to allow the cooling and
heating functions to be operated. The conditioner must be
activated for cooling or heating in order to test them.
Assembling air ducts and external shutters
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Innova 2.0 verticale at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Innova 2.0 verticale in the language / languages: English as an attachment in your email.

The manual is 3,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info