800608
13
Zoom out
Zoom in
Previous page
1/16
Next page
13
GB
After pressing the ON / OFF button for the second time, the device will stop emitting heat but
the fan will remain in operation for another 30 seconds, after which the device will return to
stand-by mode.
2. Speed: the speed selection function is not available when the product is in “Heating” mode.
3. Wind/heat: Press the “Wind / Heat” button to select the desired heat intensity. Each time
this button is pressed, an indicator will light up on the screen to indicate the type of intensity
selected. There are 2 levels of heating intensity: low (1000W) or high (2000W).
4. Timer: press the “Timer” key to set the operating time of the fan (from 0 to 12 hours). This
setting allows the unit to enter standby mode after the set time. Press the “Timer” button to
increase the operating time of one unit at a time. To deactivate this function, simply press the
“Timer” button until the display shows “00”.
5. Swing: press the “Swing” key to activate the swing function of the wings. Once the “swing”
button is pressed, the appropriate icon will appear on the control panel. To deactivate the
swing function, press the “Swing” key again. The airow direction can be adjusted manually
by arranging the appropriate air wings.
6. Cooler: the cooling function is not available when the product is in “Heating” mode.
7. Ionizer: press the “Ion” button to activate the ionizer function. The appropriate function
icon will light up on the display and the release of negative ions will start.
How to fill the tank
Check the water level in the tank frequently, making sure that it never goes below the “MIN”
level indicated in the tank itself. The activation of the “cooling” function with an insufcient
amount of water may cause the malfunction of the water pump making void the warranty.
ATTENTION: Before proceeding with the filling of the tank, make sure to first
disconnect the device to the mains.
How to use ice tablets
By inserting the ice tablets into the tank, a fresher jet of air can be obtained.
• Store them for a couple of hours in the freezer.
• Once the water is frozen inside them, the ice boards are ready to be stored in the tank.
Proceed by pouring the water into the tank until reaching the indicated MAX level.
CLEANING AND MAINTENANCE
Dust accumulating on the dust lter may prevent proper air ow. Therefore we recommend to
clean the lter and all its parts regularly, following the instructions below. Before proceeding
with any maintenance or cleaning operation, switch off the appliance and remove the plug
form the main socket. Never clean the product components with ammable liquids. The
vapours may cause re or explosion.
Dust Filter
To remove the dust lter, simply press the two release levels located at the top of the lter
down to remove it. Use a mild detergent and a soft brush to clean and remove dust and dirt
from the lter. Put the lter on again inserting the bottom rstly and pushing the upper part
to lock it.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Innoliving INN-508 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Innoliving INN-508 in the language / languages: English, Italian as an attachment in your email.

The manual is 0.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info