800608

Innoliving INN-508 Manual

12
Zoom out
Zoom in
Previous page
1/16
Next page
12
GB
medium speed and the low speed and a pause of 6 seconds.
2. If the fan speed is set to MID, the Natural mode will alternate the medium speed, the low
speed and a pause of about 6 seconds.
3. If the fan speed is set to LOW, the Natural mode will alternate only the low speed with a
pause of approximately 6 seconds.
Sleep Mode (Sleep): ventilation alternates between different ventilation speeds, then reduces
to remain constant. The lowering of the fan speed depends on the previously set speed with
the “Speed” button:
1. If the ventilation speed is set to HIGH, the Sleep mode will alternate the maximum speed,
the medium speed, the low speed and a pause of around 6 seconds. After 30 minutes, the
speed will remain constant at the medium speed of ventilation.
2. If the ventilation speed is set to MID, the Sleep mode will alternate the medium speed, the
low speed and a pause of about 6 seconds. After 30 minutes, the speed will remain constant
at the low speed of ventilation.
3. If the fan speed is set to LOW, the Natural mode will alternate only the low speed with a
pause of approximately 6 seconds. After 30 minutes, the speed will remain constant at the
low speed of ventilation.
4. Timer: press the “Timer” key to set the operating time of the fan (from 0 to 12 hours). This
setting allows the unit to enter standby mode after the set time. Press the “Timer” button to
increase the operating time of one unit at a time. To deactivate this function, simply press the
“Timer” button until the display shows “00”.
5. Swing: press the “Swing” key to activate the swinging function of the aps Once the
“swing” button has been pressed, the appropriate icon will appear on the control panel.To
deactivate the swing function, press the “Swing” button again. The airow direction can be
adjusted manually by arranging air wings.
6. Cooler: press the “Cooler” button to activate the cooling function.
Attention: do not activate the cooling function if the water level in the tank is below the
minimum level indicated or there is no water in the tank.
Before activating this function, check the water level and ll the tank if necessary. Replace
stale water with fresh water. It is advisable to replace the water in the tank at least once a
week.
Once the “cooling” function has been activated, the water pump will start to draw water
from the tank, making it pass through the cooling pad; in this way the evaporated air is
expelled with the help of the fan.
7. Ionizer: press the “Ion” button to activate the ionizer function. The appropriate function
icon will light up on the display and the release of negative ions will start.
HEATING FUNCTION:
Set the switch (5) in the Heating position.
1. ON / OFF: Press the “ON / OFF” button on the control panel or press the ON / OFF button
on the remote control to turn the unit on. The unit will start with a normal ventilation speed
and a low heating level (1000 W).
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Innoliving INN-508 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Innoliving INN-508 in the language / languages: English, Italian as an attachment in your email.

The manual is 0.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info