Manual Inglesina Trilogy (page 28 of 136) (English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish)

768074

Zoom out

Zoom in

1/136

lining periodically for correct maintenance.

HUGGY INFANT CAR SEAT (IF AVAILABLE)

AT TAC HING THE INFANT CAR SEAT TO THE CHASSIS

g. 32 Take the infant car seat from the handle and attach

it to the chassis in correspondence of the housings on

both sides of the structure and place it solely in rear facing

position.

g. 33 CAUTION: make sure that the infant car seat is

properly attached before use.

DETACHING THE INFANT CAR SEAT FROM THE CHASSIS

g. 34 Use the lever (S1) on the rear of the infant car seat.

g. 35 Simultaneously, lift the seat by holding it by the

handle.

To use the Huggy infant car seat properly, refer to the

dedicated manual.

PUSHCHAIR SEAT

AT TAC HING THE PUSHCHAIR SEAT TO THE CHASSIS

g. 36 Attach the pushchair seat to the chassis, in

correspondence of the housings on both sides of the

structure.

g. 37 CAUTION: make sure that the pushchair seat is

properly attached before use.

g. 38 The pushchair seat can be used in rear facing and

forward facing position, and the chassis can be folded with

the pushchair seat attached.

DETACHING THE PUSHCHAIR SEAT FROM THE CHASSIS

g. 39 Press the handles (R5) simultaneously and lift the

pushchair seat o the chassis.

CAUTION: do not, under any circumstance, carry out this

operation with the baby inside.

ADJUSTING THE BACKREST

g. 40 The backrest can be adjusted to 3 positions; use

the central device (R6) and bring the backrest to the desired

position.

ADJUSTING THE FOOTREST

g. 41 To lower the footrest, use both levers (R7)

positioned on the lower part and simultaneously press them

downwards.

g. 42 To lift the footrest, simply pull it upwards and it

shall automatically lock into position.

SAFETY BELT S

g. 43 Ensure that the safety belts are inserted in the

eyelets at the height of the shoulders or immediately above.

If the position is not correct, remove the belts from the rst

pair of eyelets and reinsert them in the second one; always

use eyelets at the same height.

g. 44 Make sure that the back strap is properly inserted in

the ends of the waist one.

g. 45 Fasten the ends of the strap belt to the central

buckle.

g. 46 The waist strap must always pass through the side

loops (R8) and, when being used, it must be adjusted in order

to properly secure the baby.

g. 47 Always use the crotch strap together with the waist

one, adjusting both of them properly.

CAUTION! Failure to comply with this precaution can

cause the baby to fall or slide out, with serious injury

risks.

AT TAC HING THE HANDRAIL

g. 48 Mount the handrail (R1) by pressing the buttons

(R9) and attach it in correspondence of the relative housings

on the pushchair seat (R10).

g. 49 The handrail can be open on one side or fully

removed; to open it, press the button (R9) and remove it from

its housing; to remove it, repeat the procedure on the other

side.

AT TAC HING THE HOOD

g. 50 The hood is mounted onto the stroller by

positioning it in correspondence of the 2 housings (R11)

on the pushchair seat and inserting the slides (H1), pushing

until they both click into place.

g. 51 Fasten the press studs of the lining to the backrest,

starting with the upper ones (H2) and then with the lower

ones (H3).

g. 52 To adjust the hood, simply accompany it to the

desired position.

DETACHING THE HOOD FROM THE STROLLER

g. 53 To remove the hood from the stroller, unfasten the

press studs that secure the lining to the backrest (H2-H3).

g. 54 Then adjust the lever (H5) and simultaneously

extract the hood from the housings (R11) on the pushchair

seat.

HOOD LINING MAINTENANCE

g. 55 The hood lining can be removed to allow for its

correct maintenance. Unfasten the buttons (H6) on both

hood joints (H7).

g. 56 Detach both joints (H7) from the binding (H8) and

remove the lining.

g. 57 To remount the lining, insert both bindings (H8) in

the guides on the internal lining.

g. 58 Insert the bindings (H8) in their housings on both

joints (H7), until fully attached.

MUFF (IF AVAILABLE)

g. 59 Place the mu (R3) making it pass under the

handrail.

g. 60 Button up the central binding (F1), making it pass

through the ring (F2).

g. 61 The mu reverse can also be attached in a suitable

position for protecting the child against cold weather.

g. 62 The mu can be used on both rear facing and

forward facing pushchair seats.

RAIN COVER (IF AVAILABLE)

g. 63 To mount rain cover (R4), place it on the hood and

button up the snap fastners on the side (P1).

g. 64 Fasten the elastic straps (P2) around the front

tubes, in correspondence of the wheel assembly.

MAINTENANCE OF THE LINING

It is recommended to remove the lining periodically to

provide for its correct maintenance.

g. 65 Detach the two lower elastic straps (R12) from the

footrest, removing it from its supports (R14).

g. 66 Unfasten the buttons on the seat (R15).

fig. 67 Remove the elastic strap (R16) and unfasten the

buttons (R17) on both sides of the pushchair seat.

g. 68 Unfasten the buttons on the eyelets and on the

backrest (R18).

g. 69 Extract the shoulder pads from the back straps.

g. 70 Remove the waist strap from the side loops (R8) ,

taking care to make the rst tooth of the central buckle pass

through the side loop before removing it completely.

g. 71 Remove the crotch strap from the protection built

into the lining (R19).

g. 72 Pass the shoulder straps and the crotch strap

through the eyelets on the lining and remove it completely.

WARNING: make sure that the lining has been properly

reassembled before use.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Inglesina Trilogy in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 9,9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Inglesina Trilogy Manual

Product: