513179
7
Zoom out
Zoom in
Previous page
1/52
Next page
The Controls
Active Light
Cool Tumble
phase
Crease Care
phase
This light will glow whenever a programme is active (running).
If this light flashes it shows that an automatic programme has
exceeded 180 minutes. For safety reasons this being the maximum
drying time available.
Should this occur, the causes may be:
The load is too big, or bulky.
The filter is blocked.
A cotton load was spun at LOW speed.
There may be a fault.
Turn the dryer Off, check through the first three causes, and then try
again.
About 10 minutes before the programme is completed, the heating
elements will be switched off, and the programme enters the final
‘Cool Drying’ phase. During this phase, the fabric is cooled. You
should always allow the dryer to complete this phase.
By opening the door, you can check the dryness of the load as often
as you wish and if you want remove some items before they are fully
dry. (This is particularly useful for a mixed load where you want to iron
some items, but others to be fully dried.)
You will need to press the START button after closing the door to
re-start the programme. See previous page.
At the end of the drying programme it may not be convenient to take
out the clothes immediately. Do not worry, the dryer will protect your
clothes from creasing by gently turning them over occasionally by
means of a few revolutions of the drum. At the same time, if you have
not cancelled the Alarm (Buzzer) a warning buzz will sound
intermittently to remind you that the clothes are ready to take out.
Easy Iron Programme
When to use
‘Easy Iron’
Important!
Audio Signal
‘Easy Iron’ provides a short programme consisting of approximately 8
minutes of heat with an approximately 2 minutes cool tumble period. It
is a short conditioning programme that softens the fibres allowing them
to relax making handling and ironing easier and less time consuming.
However garments are dried, outside on the line, inside on a radiator,
hung around the home or using a tumble dryer, once dry they usually
get left in the same position/place for a long period of time. This tends
to cause garment fibre stiffness which can make the handling of
garments difficult and therefore the ironing time longer. Garments
dried in any of the ways described above and left will benefit from the
‘Easy Iron’ programme.
The ‘Easy Iron’ cycle is not a drying programme. It has been
designed to condition/soften garments that have already been
dried and left unattended in this state for a period of time.
All materials do not behave in exactly the same way when heated.
For instance, our testing has shown that materials such as
Tencel® and Acrylics are not relaxed quite as effectively by
applying the ‘Easy Iron’ cycle as we found on the more traditional
Cottons and Polycottons.
To obtain the best results from ‘Easy Iron’ it is important that the
weights recommended below are not exceeded.
For best results We recommend garments should be
removed from the dryer immediately after the ‘Easy Iron’
programme to be hung, folded neatly or ironed.
When this is not possible the ‘Easy Iron’ programme should
be repeated.
Recommended weights and materials
On completion of the programme an audio signal is sounded (if
selected) to remind you to remove garments from the dryer.
Material Maximum load
Cotton and Cotton mixtures 2.5kg
2kg
2kg
5.5lb
4.4lb
4.4lb
Synthetics
Denim
6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit G 84 V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit G 84 V in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info