647452
6
Zoom out
Zoom in
Previous page
1/48
Next page
6
ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS
1. The anti-tip bracket have to be attached to rear wall, as show in Fig.4, before backguard installation. The dimension
for the bracket location from the oor have to be determined after range legs have been adjusted to the proper
installation height as show in the installation instructions and the range has been levelled.
2. Measure from the oor to the bottom of the anti-tip location on the back of the range.
3. Locate the two anti-tip bracket holes (dimension of the holes 15/64”(6mm)) on the wall at the measured dimension
plus 5/32”(4mm). The two anti-tip have to be placed close to the side of the range location (recommended
dimension is 1”(25,4mm from the sides).
4. Fix the two bracket on the wall.
5. Install backguard, as shown at the next part (see Install backguard chapter).
6. Adjust range legs 5/16”(8mm) shorter than the proper installation height. Slide in then the range against the wall.
Adjust range legs to the proper installation height.
BACKGUARD INSTALLATION INSTRUCTION
Please follow the following installation instructions in sequence:
1. install base feet (see proper instruction Fig.3)
2. Place the backguard and fix it from bottom side with the two screw as shown in figure below.
Figure 3
Figure 4
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ilve UP60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ilve UP60 in the language / languages: English as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info