647427
45
Zoom out
Zoom in
Previous page
1/66
Next page
When installing the appliance it is recommended to check that the burner minimum speed (Low Flame
Setting) has been correctly adjusted. If it is necessary to change the type of gas, adjustment of the low
flame setting must be completed by the installer. To adjust the minimum setting for the burners the
following steps must be completed
Minimum flow of valve cooking hob taps
• Switch on the burner and turn the control knob towards the minimum flow position;
• Remove the knob;
• Using a screwdriver, adjust the internal screw until the correct low flame is obtained, the screw is
located just to the right of the shaft see figure 1
• Refit the knob.
Minimum flow of non-valved cooking hob taps
• Switch on the burner and turn the control knob towards the minimum flow position;
• Remove the knob;
• Insert a small screwdriver into the shaft of the gas valve and adjust the internal screw until the correct
low flame is obtained; see figure 2
• Refit the knob.
• Unscrew the adjustment screw to increase the flow, or tighten it to reduce the flow.
• The adjustment is correct when the low flame measures approximately 3 or 4 mm.
• For ULPG the adjustment screw should be turned fully clockwise.
• Make sure the flame does not go out when changing quickly from maximum flow and vice versa.
ENSURE THE MINIMUM FLAME WILL NOT BE EXTINGUISHED BY AIR DRAUGHTS
low flame adjustment of burners
freestanding cookers
45ILVE Freestanding Operating Manual
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ilve M-120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ilve M-120 in the language / languages: English as an attachment in your email.

The manual is 3,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info