806370
7
Zoom out
Zoom in
Previous page
1/92
Next page
7
– If the refrigerating appliance is
left empty for long periods, switch
o, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more
persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply (if any), electrical
connections and repairs must be
carried out by a qualied
technician. Do not repair or replace
any part of the appliance unless
specically stated in the user
manual. Keep children away from
the installation site. After
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must
be stored out of reach of children
- risk of suocation. The appliance
must be disconnected from the
power supply before any
installation operation - risk of
electrical shock.
During installation, make sure the
appliance does not damage the
power cable - risk of re or
electrical shock. Only activate the
appliance when the installation
has been completed.
Be careful not to damage the
oors (e.g. parquet) when moving
the appliance. Install the appliance
on a oor or support strong
enough to take its weight and in a
place suitable for its size and use.
Make sure the appliance is not
near a heat source and that the
four feet are stable and resting on
the oor, adjusting them as
required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant
circuit is fully ecient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
xing of the appliance must be
done in accordance with the
manufacturer instructions.
It's forbidden to place the
refrigerator in such way that the
metal hose of gas stove, metal gas
or water pipes, or electrical wires
are in contact with the refrigerator
back wall (condenser coil).
All dimensions and spacing
needed for installation of the
appliance are in the Installation
Instruction booklet.
Please remove the power cord
from condenser hook during
installation before connecting
product to power supply.
ELECTRICAL WARNINGS
It must be possible to
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream of
the socket in accordance with the
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ignis ARL 12GS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ignis ARL 12GS2 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 47.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info