30935
33
Zoom out
Zoom in
Previous page
1/47
Next page
29
9
INSTALLATION AND CONNECTIONS
Wiring the EX-2780 system cable
q Loosen the four bolts using the supplied hex head
wrench on the bottom of the scanner unit, and open
the unit. (Fig. 1)
w Loosen the nut on the scanner unit and pass the
system cable through the nut and sealing tube.
(Fig. 3)
e Connect the power cable (black and red) end to the
power unit connector through the rouped cable tie.
(Fig. 2)
r Insert the PA cable (black and white) connector to
the PA unit connector. Be sure to follow the diagram
below carefully. (Fig. 2)
t Connect the shielding wire to the chassis with the
screw as shown in the diagram. (Fig. 2)
Fix the PA cable with the rouped cable tie as illustrated
in Fig. 2.
y Clamp the system cable with the cable clamp metal
tting using a screw near the sealing connector. Be
sure to clamp it tightly. (Fig. 3)
u Clamp the system cable with the ferrite core at-
tached near the sealing connector. Be sure to clamp
it tightly. (Fig. 3)
Tighten the ferrite bead with cable tie.
i Tighten the sealing-nut (Fig. 3), then replace the
radome cover over the scanner unit. (Fig. 1)
DO NOT stretch the system cable too much, other-
wise miss contact of the connector may occur.
o Tighten the four bolts on the bottom of the scanner
unit. (Fixing torque: 9.8 Nm)
Fig. 1
CAUTION: NEVER cut the supplied system cable.
Cable tie
Power cable
PA cable
Fig. 2
Shielding wire
System cable
Sealing bush
Nut
*Ferrite bead
*Cable tieFig. 3
*Cable clamp
MR-1000R2_T2.qxd 04.2.24 10:22 Page 29
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom MR1000TII at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom MR1000TII in the language / languages: English as an attachment in your email.

The manual is 2,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info