4
ADVANCED FUNCTIONS
20
D Scan resume condition
The resume condition can be selected as a pause or timer
scan. This setting is common for all scans.
When receiving a signal, pause
scan pauses until the signal
disappears; timer scans pauses
for 10 sec.
➀ Push [(H/L)SET] for 1 sec. to enter
set mode.
➁ Push [H/L] or [TONE] one or more
times until “SC” appears.
➂ Rotate [DIAL] to select the desired
scan resume condition.
•“T- 1 0 ”: scan pauses for 10 sec. on a
received signal.
•“P-02”: scan pauses on a received signal until it disappears.
➃ Push [(VFO)CLR] to exit set mode.
D Setting a skip channel
Memory channels can be set to be skipped during memory
scan. This is useful to speedup the memory scan interval.
➀ Select the memory channel to be programmed as a skip
channel:
➥ Push [MR] to select memory mode.
➥ Rotate [DIAL] (or use the keypad) to select a memory
channel.
➁ Push [(MR)SKIP] for 1 sec. to set
the memory channel as a skip
channel.
•“SKIP” appears.
➂ Repeat step ➁ to cancel a skip
channel.
•“SKIP” disappears.
NOTE: Scan edge channels, 1A to 4B, cannot be set to
show “SKIP” settings, however, they will be skipped dur-
ing memory scan.
