56
13
HM-134 REMOTE-CONTROL MICROPHONE
■ Setting tag channels
q While pushing and holding [H/L], push [DIAL] once or twice
to select the channel group (USA and INT), if desired.
(depends on transceiver’s version)
w Push [Y]/[Z] to select the desired channel to set as a tag
channel.
e Push and hold [SCAN•TAG] for 1 sec. to set the displayed
channel as a tag channel.
• “ ” appears.
r To cancel the tag channel setting, push and hold
[SCAN•TAG] for 1 sec.
• “ ” disappears.
• Clearing all tag channels in the selected channel group
➥ While pushing and holding [H/L], push [SCAN•TAG] for 3
sec. to clearing all tag channels. (until long beep changes
to 2 short beeps)
■ Dualwatch/Tri-watch
operation
q Push [Y]/[Z] to select the desired channel.
•While pushing and holding [H/L], push [DIAL] once or twice to
select the channel group (USA, INT), if desired. (depends on
transceiver’s version)
w Push [DUAL] to start dualwatch or tri-watch.
•“DUAL” appears during dualwatch; “TRI” appears during tri-
watch.
• Beep tone sounds when a signal is received on Channel 16.
• Tri-watch becomes dualwatch when receiving a signal on the call
channel.
e To cancel dualwatch/tri-watch, push [DUAL•IC] again.
